Abstract:The study systematically investigates the ductile-brittle transition behavior, material removal mechanism, and end-face turning performance of binderless tungsten carbide using in-process-heat laser-assisted diamond machining. Both numerical simulation analysis and experimental cutting experiments were conducted. To ensure that the laser loading condition and energy distribution were consistent with the ray-tracing simulation and spatial power density distribution measurement, a practical thermal simulation model was created with a semicircular Gaussian distribution. This model was then used to study the temperature distribution, and the material's thermal transient response to laser radiation was also analyzed in detail. The high-temperature nanoindentation revealed increased ductile machinability due to plastic deformation, microhardness reduction, and Young's modulus decrease at elevated temperatures, providing fundamental support for the ductile-brittle transition behavior. The ductile-brittle transition depth increased by 247.20% compared to conventional groove cutting without laser assistance. The cutting forces during groove cutting decreased gradually with increasing laser power, but excess laser power may cause fluctuations in cutting forces due to surface high-temperature oxidation and potential thermal expansion. The ductile-brittle transition dynamic behavior analysis, based on the discrete wavelet transform algorithm, showed good consistency with the conventional groove profile analysis. The friction coefficient between the tool rake face and chip decreased with increasing laser power, which facilitated improving the tool life. The statistical analysis of end-face turning experiments based on the Taguchi method indicated that laser power was the most significant factor affecting surface quality. The verification turning experiments validated the determined optimal parametric combination. Ultra-high-quality spherical lenses were obtained in ductile cutting mode with slightly less tool wear, a more homogeneous finish (less than 3 nm in Sa), and more outstanding form accuracy (133 nm in PV) compared to conventional turning without laser assistance.

Wear Resistance of Laser Brazing Diamond Coating with and Without Pre-Machining V-groove on Diamond Surface

Laser Power Effects on Properties of Laser Brazing Diamond Coating

Research on Interface Structure and Performance of Diamond Brazed Coating Based on Non-Vacuum Environment

Influence of Laser Scanning Speed on the Formation Property of Laser Brazing Diamond Coating

Microstructure and properties at bonds of diamond grains and Ni Cr filler alloy by fiber laser brazing

Wear-resistance of Diamond-like Carbon Thin Films Deposited on the Metal Seal Ring Surface by Plasma Gun at an Atmospheric Pressure

Comparative analysis of the brazing mechanism and wear characteristics of brazed diamond abrasive with Zr-alloyed Cu-based filler metals

Study on the effect of laser-assisted machining on tool wear based on molecular dynamics simulation

Laser Melting and Surface Texture Technology: Effect on Friction Properties

Brazing of Large Synthetic Diamond Grits Using Graphene Nanoplatelets Reinforced NiCr Composite Fillers

Interfacial characteristics and thermal damage of brazed W-coated diamond with Ni- based filler alloy

Microstructure and Mechanical Properties of Pre-Brazed Diamond Abrasive Grains Using Cu–Sn–Ti Alloy

Influence of the grain size of CVD diamond on the thermal conductivity, material removal depth and surface roughness in nanosecond laser machining

High-deposition laser brazing with enhanced surface quality, bridge performance and mechanical properties

Preparation and performance of grinding wheel with orderly arranged abrasive particles based on laser processing technology

Microstructures and Wear Resistance of FeCoCrNi-Mo High Entropy Alloy/Diamond Composite Coatings by High Speed Laser Cladding

Water Assisted Pulsed Laser Machining of Micro-Structured Surface on CVD Diamond Coating Tools

Additional Tribological Effect of Laser Surface Texturing and Diamond-Like Carbon Coating for Medium Carbon Steel at Near Room Temperature

Wear evolution of microstructured diamond grains in WC/Co cemented carbide single grain scratching

Anti-Wear Property of Laser Textured 42CrMo Steel Surface

Ultra-precision cutting characteristics of binderless tungsten carbide by in-heat-process laser-assisted diamond machining