Abstract:The study systematically investigates the ductile-brittle transition behavior, material removal mechanism, and end-face turning performance of binderless tungsten carbide using in-process-heat laser-assisted diamond machining. Both numerical simulation analysis and experimental cutting experiments were conducted. To ensure that the laser loading condition and energy distribution were consistent with the ray-tracing simulation and spatial power density distribution measurement, a practical thermal simulation model was created with a semicircular Gaussian distribution. This model was then used to study the temperature distribution, and the material's thermal transient response to laser radiation was also analyzed in detail. The high-temperature nanoindentation revealed increased ductile machinability due to plastic deformation, microhardness reduction, and Young's modulus decrease at elevated temperatures, providing fundamental support for the ductile-brittle transition behavior. The ductile-brittle transition depth increased by 247.20% compared to conventional groove cutting without laser assistance. The cutting forces during groove cutting decreased gradually with increasing laser power, but excess laser power may cause fluctuations in cutting forces due to surface high-temperature oxidation and potential thermal expansion. The ductile-brittle transition dynamic behavior analysis, based on the discrete wavelet transform algorithm, showed good consistency with the conventional groove profile analysis. The friction coefficient between the tool rake face and chip decreased with increasing laser power, which facilitated improving the tool life. The statistical analysis of end-face turning experiments based on the Taguchi method indicated that laser power was the most significant factor affecting surface quality. The verification turning experiments validated the determined optimal parametric combination. Ultra-high-quality spherical lenses were obtained in ductile cutting mode with slightly less tool wear, a more homogeneous finish (less than 3 nm in Sa), and more outstanding form accuracy (133 nm in PV) compared to conventional turning without laser assistance.

Thermal defects generation mechanism in laser precision dressing of metal-bonded micro-groove diamond wheel and their influence on grinding silicon wafer

Laser dressing of fine-grained metal-bonded diamond grinding wheels with concave surface

Wafer chamfering grinding wheels dressing via dynamic deflection laser beam

Nano-Precision Synergistic Finishing Process Integrated ELID-Grinding and MRF

Micro-grooving of brittle materials using textured diamond grinding wheels shaped by an integrated nanosecond laser system

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Improvement of precision grinding performance of CVD diamond wheels by micro-structured surfaces

Preparation of surface micro-structured coarse-grained diamond wheels based on high efficiency mechanical conditioning and picosecond pulsed laser machining

Precision dressing of arc-shaped coarse-grained diamond wheels via electrical discharge aided grinding technology

Effects of processing parameters and grinding direction on the material removal mechanism of (100) surface single crystal diamond in self-rotating mechanical grinding

Preparation and performance of grinding wheel with orderly arranged abrasive particles based on laser processing technology

Precision grinding of engineering ceramic based on the electrolytic dressing of a multi-layer brazed diamond wheel

Research on the Grinding Performance of an Electroplated Coarse-Grained Diamond Grinding Wheel by Dressing

Laser-assisted surface grinding of innovative superhard SiC-bonded diamond (DSiC) materials

Laser Grinding of Single-Crystal Silicon Wafer for Surface Finishing and Electrical Properties

Grinding performance evaluation of SiC ceramic by bird feather-like structure diamond grinding wheel

High surface integrity fabrication of silicon wafers using a newly developed nonwoven structured grind-polishing wheel

Grinding damage of BK7 using copper-resin bond coarse-grained diamond wheel

Ultra-precision cutting characteristics of binderless tungsten carbide by in-heat-process laser-assisted diamond machining

Molecular Dynamics Study of Nano-Grinding Behavior for Silicon Wafer Workpieces with Nanoscale Roughness Under Diamond Abrasive Rotation and Translation

The study of the resin-bond diamond wheel for IC silicon wafer nanoscale roughness back grinding