Abstract:This paper establishes a new model for predicting machined surface topography and anisotropic texture direction in peripheral milling. Unlike previous models, this model takes into account the largest number of influential factors, i.e., tool setting error (radial offset and axial tilt), static tool deflection, forced vibration, chatter vibration, and stochastic tool grinding error and wear (STGEW). STGEW, quantified by the normal distribution (mu, sigma(2)), is incorporated into the model for the first time. The model predictions for 3D surface topography, anisotropic texture direction, 2D surface profile or roughness agree remarkably well with experimental or published results, under both stable and unstable milling conditions. It is found that static deflection slightly attenuates the effect of tool setting error on roughness. Even machining with fresh tools or tools with very small cutting length (<15 mm) and wear (VB similar to 5 mu m), inherent STGEW creates random scratches with different geometries parallel to feed direction on the milled surface. STGEW expands the difference of roughness in axial direction. STGEW induces an additional surface texture in feed direction, which co-exist with axial texture contributed by feed marks when standard deviation sigma to feed rate f(t) ratio is small. As sigma increases, (1) feed marks are gradually obliterated by scratches, and surface texture is only oriented in feed direction; (2) the mean and variance of roughness in both directions increase, and axial roughness prevails transverse toughness at high u. The study discovers that, STGEW, even with small sigma (e.g., sigma=[0.01 mu m, 0.1 mu m]), is an important factor affecting surface topography, anisotropic surface texture direction and roughness that cannot be ignored, especially in the case of low-feed machining, e.g., f(t) = 0.05 mm, which is commonly adopted in finish-milling of difficult-to-cut materials. The proposed model can be used to reliably and accurately predict surface topography, surface roughness and surface texture direction in peripheral milling operation.

Undeformed Chip Width Non-Uniformity Modeling and Surface Roughness Prediction in Wafer Self-Rotational Grinding Process

An Intelligent Prediction of Surface Roughness on Precision Grinding

The material removal and surface generation mechanism in ultra-precision grinding of silicon wafers

Prediction and Measurement for Grinding Force in Wafer Self-Rotational Grinding

Simultaneous double side grinding of silicon wafers: A further investigation into grinding marks pattern

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Effects of Wheel Spindle Vibration on Surface Formation in Wafer Self-Rotational Grinding Process

Introducing abrasive wear into undeformed chip thickness modeling with improved grain kinematics in belt grinding

Modeling and Simulation of Grinding Surface Topography Considering Wheel Vibration

Ductile deformation and subsurface damage evolution mechanism of silicon wafer induced by ultra-precision grinding process

Prediction of undeformed chip thickness distribution and surface roughness in ultrasonic vibration grinding of inner hole of bearings

Surface Roughness Model of Ground 4H-SiC Considering Ductile and Brittle Removal

An Investigation of the Surface Waviness Features of Ground Surface in Parallel Grinding Process

Analytical prediction for depth of subsurface damage in silicon wafer due to self-rotating grinding process

Modeling on the Flatness of Silicon Wafers Ground by the Grind-polishing Wheel

A parametric evaluation model of abrasive interaction for predicting tooth rough surface in spiral bevel gear grinding

Surface Generation and Material Removal Mechanism Incorporated with the Randomness of Grain Size and Distribution in Grinding

Three-dimensional modelling and simulation of vibration marks on surface generation in ultra-precision grinding

Study of deterministic surface micro-texture generation in ultra-precision grinding considering wheel oscillation

An improved chip-thickness model for surface roughness prediction in robotic belt grinding considering the elastic state at contact wheel-workpiece interface

Modelling of Machined Surface Topography and Anisotropic Texture Direction Considering Stochastic Tool Grinding Error and Wear in Peripheral Milling