Abstract:Herein, a boundary lubrication (BL) mechanism based on the carbon-based tribofilms formed via Ni(Cu)-catalytic dehydrogenation of hydrocarbon oils was queried by performing standard ball-on disk tribotests on magnetron-sputtered WN, Ni, and W-N-Ni coatings in the oil-starvation condition. The experimental results indicate that both the bare GCr15 steel substrate and the sputtered W-N-Ni/MoN-Cu coatings exhibited comparable fine antiwear performance with friction coefficients below 0.09; however, no clues regarding the formation of the effectiveness of the graphite-like tribofilms on the contact surfaces were found, no matter whether the tested coatings were composited in amorphous or nanocrystallized structures. An under-s tanding of the antiwear mechanism was achieved by conducting a nonequilibrium molecular dynamics (NEMD) simulation of the confined shearing process, taking 1-decene chains as a model of the poly-alpha-olefin 10 base oil. It was found that as the normal load increases from 0.14 to 9.2 GPa, the "sandwiched" sheared oil molecules undergo a liquid-to-solidlike phase transition at a threshold pressure of approximately 0.54 GPa, above which the solidified oil film responds as an elastic protective layer between rigid walls and provides lower friction coefficients and energy dissipation than those of laminar shear motion. The main reasons are the elastic compliance of solidlike oil molecules and the occurrence of boundary slippage on the liquid-wall interface. The comparison of NEMD simulation among confined sheared boundary films of nonhydrogenated diamond-like carbon (DLC), hydrogen-terminated DLC, laminar fluid layers, and solidified oil films further reveals that it is the flexibility of C-C backbones as well as the elastic compliance of terminal C-H bonds that play a dominant role in the low-friction behavior of solidlike oil films in oil-starvation lubrication. Moreover, the simulation results indicate that the temperature increment of the confined sheared 1-decene under 0.14-9.2 GPa loads is generally below 20 K, which is far below the active temperature of 1-decene's catalytic dehydrogenation and pyrolysis reaction. These results support that in a steady state BL with low friction coefficients at room temperature, the formation of lubricious tribofilms via catalytic dissociation of alkanes can hardly be triggered due to the limited temperature increment, even when the catalysts of Ni/Cu are composited in the sliding surfaces.

Coupling Effect of Boundary Tribofilm and Hydrodynamic Film

Graphene-induced reconstruction of the sliding interface assisting the improved lubricity of various tribo-couples

Role of Interfacial Bonding in Tribochemical Wear

Tribofilm Formation and Friction Reduction Performance on Laser-Textured Surface with Micro-Grooved Structures

Dynamics of Tribofilm Formation in Boundary Lubrication Investigated Using In Situ Measurements of the Friction Force and Contact Voltage

Nanostructure of Superlubricating Tribofilm Based on Friction-Induced a-C:H Films under Various Working Conditions: A Review of Solid Lubrication

Study on the Tribological Properties of Hexagonal Boron Nitride Flakes Composite Hydrophilic/hydrophobic Ionic Liquids Films by Self-Assembly

Shear-induced interfacial reconfiguration governing superlubricity of MoS2-Ag film enabled by diamond-like carbon

Influence of Tribofilm on Superlubricity of Highly-Hydrogenated Amorphous Carbon Films in Inert Gaseous Environments

Comparative study on boundary lubrication of Ti3C2Tx MXene and graphene oxide in water

In-situ tribo-induced formation of superb lubricious carbon-based tribofilms on the catalytical active MoN-Ag film surfaces

Tribo-Induced Interfacial Material Transfer of AFM Probe Assisting Superlubricity in WS 2 /Graphene Heterojunction.

Tribology of Two-Dimensional Materials: from Mechanisms to Modulating Strategies

Mitigating friction and wear by pre-designed or tribo-induced heterostructures: an overview

Elastic Lubricious Effect of Solidlike Boundary Films in Oil-Starvation Lubrication

Ultra-Wear-Resistant MXene-Based Composite Coating Via in Situ Formed Nanostructured Tribofilm

Study of Transition from Full-film to Boundary Lubrication

Interfacial Nanostructure of 2D Ti3C2/Graphene Quantum Dots Hybrid Multicoating for Ultralow Wear

Ultra-Low Friction System Using Special Wetting Interfaces: Bridging Across Various Wetting Regimes

Structural and environmental dependence of superlubricious properties in hydrogenated Graphite-Like carbon Films: Implications in solid state lubrication

Multilayer Tribofilm: An Unique Structure to Strengthen Interface Tribological Behaviors