Abstract:Nitrogen dioxide (NO2) is a major pollutant, causing acid rain, photochemical smog, and respiratory damage. The annual safe limit is 50 parts per billion (ppb), while concentrations exceeding 1 part per million (ppm) can result in respiratory ailments. Conventionally, n-type metal oxide semiconductors operating at elevated temperatures have been utilized for NO2 detection. Recently, p-type semiconductors with their hole accumulation layer, rapid recovery post-gas exposure, and good humidity tolerance are being investigated as potential NO2 sensors, once again working at elevated temperatures. In this work, a room-temperature (27 ± 2 °C) NO2 sensor is demonstrated by using a nanocomposite based on p-type bismuth ferrite (BFO) nanoparticles and silver nanowires (Ag NWs). This nanocomposite is capable of sensing a NO2 gas concentration of up to 0.2 ppm. The BFO nanoparticles are synthesized via a sol-gel route followed by sintering at 500 °C to form the crystalline phase. Nanocomposites are obtained by formulating a dispersion of the BFO nanoparticles and Ag NWs, followed by direct writing on both flexible and rigid substrates. The Ag NWs act as the conducting pathway, reducing the overall electrical resistance and thus enabling room-temperature operation. X-ray diffraction, scanning electron microscopy, and surface area studies provide phase information and surface morphology, and the porous nature of the film helps in room-temperature gas adsorption. The current-voltage and gas-sensing behavior are studied to obtain the optimized molar ratio (4:1 BFO/Ag NWs) for the sensor. The sensor deposited on poly(ethylene terephthalate) (PET) also works under a bent condition, indicating good flexibility. Rapid NO2 sensing was achieved in a BFO-Ag/PET device with response/recovery times of 7/8.5 s and 12/15 s in straight and bent geometries, respectively. Additionally, a good sensitivity of 30 to 60% was achieved for the BFO-Ag/PET device across 100 to 1000 ppb of NO2. The development of a nanocomposite combining an active sensing element (BFO) and a charge-transport element (Ag NWs) opens up a multitude of other application areas.

Ag2Te Nanowires for Humidity-Resistant Trace-Level NO2 Detection at Room Temperature

Bioinspired supramolecular arrayed heterojunction-based room-temperature sensor for high-performance gas detection

2D/0D SnSe2/TiO2 nanocomposites for trace NO2 detection under H2S interference at room temperature

Photochemical Fabrication of Ag‐Modified Hierarchical Cu@Cu2O/CuO Nanocomposite Toward Room Temperature NO2 Detection

In-situ grown hydrated tungsten oxide nanosheets for low temperature ppb-level NO2 detection with alleviated humidity interference

Highly-sensitive NO2 gas sensors based on three-dimensional nanotube graphene and ZnO nanospheres nanocomposite at room temperature

Bismuth Ferrite-Silver Nanowire Flexible Nanocomposites for Room-Temperature Nitrogen Dioxide Sensing

Highly Sensitive NO2 Gas Sensors Based on Hexagonal SnS2 Nanoplates Operating at Room Temperature

Gas sensors based on SnS 2 /In 2 O 3 for high performance NO 2 detection at room temperature

Heterojunctions of ZnO-Nanorod-Decorated WO 3 Nanosheets Coated with ZIF-71 for Humidity-Independent NO 2 Sensing

Highly sensitive, humidity-tolerant and flexible NO2 sensors based on nanoplate Bi2Se3 film

Design and Synthesis of Parallel Bicomponent Heterojunction Nanofibers as Flexible Room-Temperature Sensors for Ppb-Level NO 2 Detection

Highly Sensitive, Selective, Flexible and Scalable Room-Temperature NO<sub>2</sub> Gas Sensor Based on Hollow SnO<sub>2</sub>/ZnO Nanofibers

Interface Engineered WS2/ZnS Heterostructures for Sensitive and Reversible NO2 Room Temperature Sensing

Humidity-enhanced NO$_2$ gas sensing using atomically sharp edges in multilayer MoS$_2$

Room-Temperature Optoelectronic NO 2 Sensing Using Two-Dimensional Gallium Oxyselenides

DFT and experimental interpretations of silicon-based room-temperature NO 2 sensors improving humidity independence

Self-heated WO3 nanowires for selective and sensitive detection of NO2 gas at room temperature

2H-Mos2/ti3c2tx MXene Composites for Enhanced NO2 Gas Sensing Properties at Room Temperature

Cu3N-derived hydrophobic porous CuO hollow nanospheres for NO2 detection at room temperature

Highly sensitive and recoverable room-temperature NO<sub>2</sub> gas detection realized by 2D/0D MoS<sub>2</sub>/ZnS heterostructures with synergistic effects