Abstract:Deep drawing is the most advanced sheet metal forming technique. In today’s demanding environment is the global environment and energy saving, the process has been supposed to play a vital role in light-weight component industry. Light-weight, high strength, low density and extreme corrosion aspects must be almost guaranteed in a deep drawn product. However, due to those requirements, thinning and wrinkling and other defects will be increased also. Numerous elements such as blank-holder pressure, punch force, speed of punch, blank shape, thickness variation, surface-to-surface friction coefficient, material characteristic,...influenced to the success of methods as well as the quality of the products. In addition, worldwide manufacturers keep getting the most goods done in less time. Indeed, the increasing of productivity should be also dealt because it proportionally relates to the stamping speed. This paper investigates the influence of punch velocity on deformation behavior of aluminum alloy 5052–H112. Finite Element Method was used to perform Nakajima test at several of punch velocities of specimen widths and monitor fluctuations in magnitude of von Mises stress, the major strain and minor strain. Forming Limit Curve (FLC) was obtained at different velocities and almost uniform. Stretching and sliding across the top of the punch resulted in thinning of sheet metal. Beside this, the action of punch stroke resulted in the production of more von Mises concentrated stress and the largest specimen in widths had shown the peak value of von Mises stress compared with the other specimens at all different velocities. Furthermore, the ratio of the major strain to the minor strain is influenced by the mass of material at the contact area and keeps consistent over the variation in velocities of punch. This will pave the way for future studies of the optimization of the stamping speed in deep drawing.

Influence of Process Parameters and Defect Analysis in Hot Deep Drawing Process of Aluminum Alloy AA6082

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Analysis of the Stamping Speed for Sheet Metal Forming of Aluminum Alloy 5052-H112

Numerical Analysis Of Formability Of Stepped Cup In Non-Isothermal Deep Drawing Of Aluminum Alloy Sheet

Failure control on hydroforming process of thin-walled aluminum alloy with complex surface covers

Multi-Objective Optimization of Process Parameters in 6016 Aluminum Alloy Hot Stamping Using Taguchi-Grey Relational Analysis

Effect of process parameters on the deep drawing formability of aluminum and advanced high-strength steel square cups

Deep drawing of aluminum alloy 7075 using hot stamping

Research on 5A06 Aluminium Alloy Thin-wall Semisphere Hydromechanical Deep Drawing Process

Investigation of forming defects in 5A06 aluminum alloy cold stamping of thin-walled shell with corner

Effects of Process Parameters on Deep Drawing Performance of AZ31 Magnesium Alloy Sheet

Investigation on Mechanical Behavior and Plastic Damage of AA7075 Aluminum Alloy by Thermal Small Punch Test: Experimental Trials, Numerical Analysis

An Experimental and Numerical Investigation on the Formability of AA7075 Sheet in Hot Stamping Condition

Influences of Loading Paths on Thickness of Aluminium Alloy Cup with Hydro-Mechanical Deep Drawing

Research on Residual Stresses During Hot Stamping with Flat and Local-Thickened Plates

FEM model optimization study of mechanical properties and material selection in stamping process

Deformation behavior of deep drawing of 5A06 aluminum alloy plate

Optimal Thermal Process Parameters of Hot Stamping AA 6061

A General IHTC Model for Hot/warm Aluminium Stamping

Effect of tools temperature on formability of aluminium alloy sheet

An Experimental Investigation of the Drawability of AA6082 Sheet under Different Elevated Temperature Forming Processes