Abstract:The vector control of the permanent magnet synchronous motor (PMSM) is affected by cross-coupling, output delay, parameter mismatch, and other factors; thus, resulting in its poor steady-state and insufficient dynamic performance. To address these problems, the design proposed in this study adopts a model predictive current control strategy. In the traditional model predictive control, the absolute value of the difference between the predicted output current of the inverter and the reference current is used as the cost function instead of the minimum value of the valence function, i.e., the optimal solution of the system, and the best switching state is outputted. The design proposed in this study adopts the dual-vector model to predict the current control. Firstly, the reference voltage vector was predicted on basis of the deadbeat idea, which reduced the calculation burden of processor. Next, in order to further improve the stability of the system, a two-vectors duty cycle calculation method was introduced. Then, simplifies the selection range of the two voltage vectors. While ensuring the accuracy of the voltage vector, the control is reduced. Reduce the amount of calculation in the system, thereby improving its robustness. Finally, based on the principle of current vector tracking error minimization, the duration of the selected voltage vector was determined. Last but not the least, the control strategy is applied to the MTPA control to increase the operating efficiency of the control motor. The improved control strategy can effectively reduce the torque ripple and improve the dynamic and steady-state performance of the system. Simulation results verify the feasibility and effectiveness of the proposed control algorithm.

FPGA-Based Double Vectors Model Predictive Torque Control for PMSM Drives Using Maximized Parallel Implement Architecture

FPGA Implementation of Predictive Cascaded Speed and Current Control of PMSM Drives with Two-Time-Scale Optimization

Deadbeat Current Predictive Control for PMSM Drives Based on a Single FPGA with Digital Implementation Optimization

Robust Finite-Control-Set Model Predictive Torque Control of PMSM Drives Based on Dual Variable Bandwidth ESOs

Fast Response Model Predictive Torque and Flux Control with Low Calculation Effort for PMSMs

Model Predictive Direct Torque Control for PMSM Drives in M–T Frame

Predictive Cascaded Speed and Current Control for PMSM Drives with Multi-Timescale Optimization

Speed Control for Variable Speed PMSM Drive System Using Nonlinear Variable-Horizon Predictive Functional Control

MODEL PREDICTIVE DIRECT TORQUE CONTROL FOR SPMSM WITH LOAD ANGLE LIMITATION

Multiobjective Finite Control Set Model Predictive Control Using Novel Delay Compensation Technique for PMSM

A Double Vector Model Predictive Torque Control Method Based on Geometrical Solution for SPMSM Drive in Full Modulation Range

SM Load Torque Observer-Based FCS-MPDSC with Single Prediction Horizon for High Dynamics of Surface-Mounted PMSM

Deadbeat Model-Predictive Torque Control With Discrete Space-Vector Modulation for PMSM Drives

Model Predictive Direct Torque Control for PMSM with Duty Cycle Optimization

Computationally efficient multi‐step direct predictive torque control for surface‐mounted permanent magnet synchronous motor

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

An Improved Model Predictive Torque Control for PMSM Drives Based on Discrete Space Vector Modulation

A FCS-MPTC Method Based on Discrete Space Vector Modulation with Reduced Computation Burden for PMSM

A Low-Complexity Three-Vector-Based Model Predictive Torque Control for SPMSM

Finite Control Set Model Predictive Torque Control With Reduced Computation Burden for PMSM Based on Discrete Space Vector Modulation

MTPA control of permanent magnet synchronous motor based on dual-vector model predictive control