Abstract:Journal of Reinforced Plastics and Composites, Ahead of Print. The silicon carbide particle-reinforced matrix composites, or SiCp/Al, have excellent mechanical qualities, but producing them is quite difficult since the SiC particles' and the Al matrix's properties differ greatly from one another. During the cutting process, the Ra local oscillation phenomena takes place; that is, surface roughness seems to grow, decrease, and then increase as the cutting depth increases within a particular cutting depth range while maintaining the same cutting speed and feed. To find out why this behavior occurred, a cutting experiment and a simulation analysis of SiCp/Al composites were performed. Tests were conducted to find out how varied cutting depths affected surface roughness, and a finite element model for two-dimensional cutting was created. Based on the data, it can be concluded that Ra's local oscillation phenomena is responsible for the surface quality at various cutting speeds. At 100 mm/s, 200 mm/s, 300 mm/s, and 400 mm/s, respectively, the mutation's surface quality improved by 29.6%, 14.3%, 19.6%, and 30.7% prior to the cutting depth. The analysis is justified by the fact that the depth of cut is increasing, the way in which particles are removed has changed and the percentage of scratches appears to be decreasing. As aluminium is a plastic material, plastic deformation occurs during cutting by the sub-cutting edge of the extrusion, coating the machined surfaces and producing fine cracks rather than plough furrows. In a sense, increasing the cutting thickness results in larger chips, more force on the particles in the cutting path and easier removal. At the same time, it reduces the width of the chip in future cuts, improving the surface quality of the process.

Finite Element Simulation Investigation of Surface Height Difference in Diamond Cutting of Bi-Crystal Aluminum

Controllable Diamond Cutting of Structured Surfaces with Subnanometric Height Features on Silicon

Finite element simulation and experimental investigation of crystallographic orientation-dependent residual stress in diamond cutting of polycrystalline aluminum

Three-dimensional numerical simulation for high speed milling of aerospace aluminum alloy

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Simulation and Experiment Study on Cutting Temperature in Diamond Ultra-Precision Cutting of Aluminum Alloy Mirror

Finite element and experimental analysis of surface integrity and surface roughness of precision machining SiCp/Al

The Study of the Influence of Tool Wear on Cutting Temperature in Diamond Ultra-Precision Cutting of Aluminum Alloy Mirror

Theoretical and Experimental Investigation on Inclined Ultrasonic Elliptical Vibration Cutting of Alumina Ceramics

Atomic simulation for the effect of nano-cutting parameters on the 3D surface morphology of polycrystalline γ-TiAl alloy

3D Finite Element Simulation and Experiment of Residual Stress on the Cutting Surface

Coupled effect of tool geometry and tool-particle position on diamond cutting of SiCp/Al

Grain Refinement-Induced Machined Surface Quality Promotion in Ultrasonic Vibration-Assisted Polycrystalline Diamond Cutting of Polycrystalline Cu

Study on the High-Speed Milling Performance of High-Volume Fraction SiCp/Al Composites

Atomistic investigation of machinability of monocrystalline 3C–SiC in elliptical vibration-assisted diamond cutting

Numerical simulation of materials-oriented ultra-precision diamond cutting: Review and outlook

Computational investigation on the surface cutting of γ-TiAl alloy

Finite Element Simulation and Experimental Research in Cutting Forces of KDP Crystal

Multiscale Simulation of Nanometric Cutting of Single Crystal Aluminium

The Experiment Investigation of the Tool Wear in Diamond Ultra-Precision Cutting of Aluminum Alloy Mirror

Research on three-dimensional finite element modeling based on B4Cp/Al meso-structure and cutting simulation