Abstract:An experimental and computational investigation directed at understanding the role of buoyancy-driven convection during constrained melting of phase change materials (PCM) inside a spherical capsule is reported. The computations are based on an iterative, finite-volume numerical procedure that incorporates a single-domain enthalpy formulation for simulation of the phase change phenomenon. A Darcy’s Law-type porous media treatment links the effect of phase change on convection. Paraffin wax n-octadecane was constrained during melting inside a transparent glass sphere through the use of thermocouples installed inside the sphere. The melting phase front and melting fraction of the PCM are analyzed and compared with numerical solution obtained from the CFD code Fluent. Following a short period of symmetric melting due to prominence of diffusion, expedited phase change in the top region of the sphere and a wavy surface at the bottom of the PCM are observed. The computational predictions point to the strong thermal stratification in the upper half of the sphere that results from rising of the molten liquid along the inner surface of the sphere thus displacing the colder fluid. The waviness and excessive melting of the bottom of the PCM is shown to be underestimated by the experimental observation. This discrepancy is linked to the use of a support structure to hold the sphere. Measured temperature data and computational results near the bottom indicate the establishment of an unstable fluid layer that promotes chaotic fluctuations and is responsible for waviness of the bottom of the PCM. On the other hand, the comparison between the measured and computed temperatures in the top half of the sphere show the stable nature of the molten liquid layer. The computational results start to deviate from the thermocouple readings as one moves lower from the top of the sphere. This delay in predicting the melting instant is linked to the thermal stratification within the “constant temperature bath” that encloses the capsule.

Pore-scale study on Rayleigh-B acute accent enard convection formed in the melting process of metal foam composite phase change material

Pore-scale study on Rayleigh-Bénard convection formed in the melting process of metal foam composite phase change material

Experimental and Computational Study of Constrained Melting of Phase Change Materials (pcm) Inside A Spherical Capsule

Enhanced Thermal Management with Microencapsulated Phase Change Material Particles Infiltrated in Cellular Metal Foam

Study on the Melting Process of Phase Change Materials in Metal Foams Using Lattice Boltzmann Method

Microencapsulated Phase Change Material (MEPCM) Saturated in Metal Foam As an Efficient Hybrid PCM for Passive Thermal Management: A Numerical and Experimental Study

Visualized-experimental investigation on the energy storage performance of PCM infiltrated in the metal foam with varying pore densities

Experimental and Numerical Studies on Melting Process of Phase Change Materials (pcms) Embedded in Open-Cells Metal Foams

Direct Numerical Simulation on Melting Phase Change Behavior in Open-cell Metal Foam

Experimental and Numerical Study on Melting of Phase Change Materials in Metal Foams at Pore Scale

Thermal effect of nanoparticles on the metal foam composite phase change material: A pore-scale study

A New Strategy for Enhanced Latent Heat Energy Storage with Microencapsulated Phase Change Material Saturated in Metal Foam

Effect of filling configurations on melting heat transfer characteristic of phase change materials partially filled with metal foam

Melting of Phase Change Materials Inside Metal Foams with Uniform/graded Porosity: Pore-scale Simulation

Effect of Natural Convection on Charging of Phase Change Materials in Graded Metal Foam: Pore-scale Simulation

A Modified Mixture Theory for One-Dimensional Melting of Pure PCM and PCM/metal Foam Composite: Numerical Analysis and Experiment Validation

Temperature Control Performance of High Thermal Conductivity Metal Foam/paraffin Composite Phase Change Material: an Experimental Study

Melting of Phase Change Materials with Volume Change in Metal Foams

Experimental Study on Heat Transfer During Melting in Metal and Carbon Foam Saturated with Phase-Change Materials for Temperature Control in Electronic Devices

Numerical study on the thermal performance of foam-metal composite phase change material in different force fields

Effect of enhancement in metal foam pore density on heat transfer of phase-change materials