Abstract:The enhancement in selectivity of nanofiltration (NF) membranes is of great significance for extending the application areas and improving the process economy, especially for the separation of monovalent/divalent ions. The characteristics of moderately increased pore size, fewer nonselective defects and a more uniform structure are conducive to NF membrane exhibiting higher rejection of divalent ions but lower rejection of monovalent ions. Nonylphenol polyoxyethylene ether (NP-10) was introduced in interfacial polymerization process in this study to optimize the microstructure and surface properties of polyamide (PA) layer to manufacture highly selective NF membranes. The hydrophobic benzene ring and aliphatic chain in NP-10 could form a local space that restricted the interfacial polymerization reaction on the side of the oil phase, thereby appropriately increasing the pore size of the PA layer. It was advantageous to the permeation of water molecules and monovalent ions with a smaller radius. The long hydrophilic oxyethylene group as a guide could facilitate the uniform diffusion of the monomer to the water/hexane interface. NP-10 as an amphiphilic substance would form a self-assembled network at the water/hexane interface, which was expected to optimize the distribution of aqueous amine monomers at the phase interface. Meanwhile, introducing NP-10 can form a stable interface and reduce the interface disturbance, thus inhibiting the formation of non-selective macropores (or “defects”) in PA layer, which could improve the separation selectivity of monovalent/divalent ions. In addition, the hydrophilicity and electronegativity were also enhanced. The results showed that the MWCO of NF membrane increased from 210.1 Da (TFC-0) to 269.6 Da (TFC-0.25), and the average pore radius increased from 0.248 nm to 0.276 nm. The water flux of optimized membrane was doubled compared to the control membrane. Most important, the optimized exhibited higher rejection of divalent Na2SO4 (from 98.07% to 99.43%), and meanwhile lower rejection of monovalent NaCl (from 54.07% to 27.52%). NaCl/Na2SO4 separation factor reached up to 130.53, which was about four times of TFC-0 membrane.

Nanofiltration membrane fabrication by the introduction of polyhedral oligomeric silsesquioxane nanoparticles: Feasibility evaluation and the mechanisms for breaking “trade-off” effect

Membranes with Negatively-Charged Nanochannels Fabricated from Aqueous Sulfonated Polysulfone Nanoparticles for Enhancing the Rejection of Divalent Anions

Polyoxometalates decoration combining with solvent activation for enhanced separation performance of nanofiltration membrane

Porous Organic Polymer Embedded Thin-Film Nanocomposite Membranes for Enhanced Nanofiltration Performance

Surface modification of nanofiltration membrane using polyoxometalates for improved separation and antifouling performance

Boosting the Performance of Nanofiltration Membranes in Removing Organic Micropollutants: Trade-Off Effect, Strategy Evaluation, and Prospective Development.

High-permeability and Anti-Fouling Nanofiltration Membranes Decorated by Asymmetric Organic Phosphate

Polyhydroxy Group Functionalized Zwitterion for a Polyamide Nanofiltration Membrane with High Water Permeation and Antifouling Performance

Breaking the Trade-off between Selectivity and Permeability of nanocomposite membrane modified by UIO66@PDA through nonsolvent thermally induced phase separation method

Study on the properties of a nanofiltration membrane with O-MoS2 nanocomposite substrate and the applications in dye wastewater treatment

Molecular Design of the Polyamide Layer Structure of Nanofiltration Membranes by Sacrificing Hydrolyzable Groups Toward Enhanced Separation Performance.

Highly permeable and acid-resistant nanofiltration membrane fabricated by in-situ interlaced stacking of COF and polysulfonamide films

Preparation of polysulfone/sulfonated polysulfone-SiO 2 nanofiltration membrane and its performance characterization

Synthesizing high performance robust PSf loose nanofiltration membranes through nanobubble-assisted pore-forming

Structurally ordered nanofiltration membranes prepared by spatially anchoring interfacial polymerization for highly efficient separation properties

High-performance nanofiltration membrane intercalated by FeOOH nanorods for water nanofiltration

Utilization of carboxyl group-grafted molybdenum disulfide for enhancing the performance of thin-film nanocomposite nanofiltration membranes

In-situ incorporating zwitterionic nanocellulose into polyamide nanofiltration membrane towards excellent perm-selectivity and antifouling performances

A novel loose nanofiltration membrane with high permeance and anti-fouling performance based on aqueous monomer piperazine-2-carboxylic acid for efficient dye/salt separation

Preparation of highly selective nanofiltration membranes by moderately increasing pore size and optimizing microstructure of polyamide layer

A nanofiltration membrane with outstanding antifouling ability: Exploring the structure-property-performance relationship