Abstract:Alloy solidification is an important process to control the mechanical properties of engineering products. During solidification, dendrite fragmentation occurs commonly as a key phenomenon to determine the microstructure and to obtain fine grain size. Recently, in situ synchrotron X-radiography technique was developed and applied to observe thermodynamic behaviors such as dendrite growth and fragmentation during solidification. External forces such as mechanical and electromagnetic stirring, and thermal shock were added into the solidification process to investigate their effects on the fragmentation behavior. However, most work conducted in literature focused on qualitative aspects e.g. morphology transition or solute distribution and quantitative investigation such as determining the specific relationship between fragmentation and solidification conditions was rather limited. In this work, the third generation synchrotron X-radiography technique was used to observe the solidification process of an Al-15%Cu (mass fraction) alloy. Experimental conditions including the strength of the pulsed electromagnetic fields, dendrite growth direction and the temperature gradients were varied and the subsequent effect on fragmentation was studied and quantified. A computer program was developed based on Matlab to perform the image processing and measurement. The fragmentation number according to experiments was counted and correlated to the mushy zone depth and local solid fraction. Results showed that a stronger electromagnetic field, growing against gravity and growing at higher velocity would significantly increase the fragmentation number. Furthermore, the fragmentation number followed a Gauss distribution as a function of either mushy zone depth or local solid fraction, and the maximum fragmentation occurred when the-solid fraction was about 0.45. In the end the extent to which caused those statistic results above were analyzed as the necking process due to the velocity field, the cumulative solid due to the gravity field and the liquid flow due to the electromagnetic field.

Fluid Flow and Vortex-Shaped Structure Formation Mechanisms Ofal-Ag-ge Alloy

Structural and Dynamical Properties of Liquid Ag74Ge26 Alloy Studied by Experiments and Ab Initio Molecular Dynamics Simulation

Formation of Heterostructure with Appearance of α-Al Phase in Hyper- and Eutectic Al-Si Alloys by Solidification at High Rate

Surface wave phenomenon and microstructure evolution mechanism of electromagnetically levitated ternary Ti-Al-Fe alloy

Amorphization in the AlC System by Mechanical Alloying

The Mechanism of Dendrite Formation in a Solid-State Transformation of High Aluminum Fe-Al Alloys

Constitutional supercooling and corresponding microstructure transition triggered by high magnetic field gradient during directional solidification of Al-Fe eutectic alloy

Evolution of solidification structure and mechanical preperties of Al7050 alloy under hypergravity

EET Research on Melt Structural Information of Magnesium Alloy

Microstructural evolution caused by electromagnetic stirring in superheated AlSi7Mg alloys

Metastable Liquid Properties and Surface Flow Patterns of Ultrahigh Temperature Alloys Explored In Outer Space

Systematic discovery of new nano-scale metastable intermetallic eutectic phases in laser rapid solidified Aluminum-Germanium alloy

Influence of Process Papameters by Vibrational Cooling-Shearing Slope on Microstructures of Semi-Solid ZAlSi9Mg Alloy

Bergman-type Medium-Range Order in Rapidly Quenched Ag0.74Ge0.26 Eutectic Alloy Studied by Ab Initio Molecular Dynamics Simulation

Interface velocity dependent solute trapping and phase selection during rapid solidification of laser melted hypo-eutectic Al-11at.%Cu alloy

Alloying/dealloying mechanisms, microstructural modulation and mechanical properties of nanoporous silver via a liquid metal-assisted alloying/dealloying strategy

Non-equilibrium Alloy Formation in the Ag–Zr System by Ion Beam Mixing

Research on homogeneous nucleation and microstructure evolution of aluminium alloy melt

Morphology Evolution of Two-Phase Cu-Ag Alloys under Different Conditions

Evolution of Deformation Substructure and MgxZnyCaz Metastable Phase in Fine-Grained Mg Alloys

QUANTIFICATION STUDY ON DENDRITE FRAGMENTATION IN SOLIDIFICATION PROCESS OF ALLUMINUM ALLOYS