Abstract:Abstract One of the primary types of sensible heat storage systems in drying applications is the packed rock bed. However, to create large‐scale heat storage systems for industrial use, one must comprehend the hydrodynamic and effectiveness of the heat transport mechanism inside the bed. In this study, the thermal storage unit uses river rock as heat storage materials with equivalent particle diameters of 36 mm in bed 1 and 56 mm in bed 2. The rocks were stacked in a truncated cone‐shaped concrete wall section with an average diameter and depth of 1.1 m and 1.3 m, respectively and a volume of 2.32 m 3 . During the charging phase, two airflow configurations were used, one from the top with an air mass flow rate of 0.753 and 0.332 kg/m 2 ‐s and the other from the bottom with an air mass flow rate of 0.955 kg/m 2 ‐s. During the discharging phase, the entire flow configuration is from the bottom section. It was observed that the mass flow rate and particle equivalent diameter had an important effect on the thermal performance and behaviour of the rock bed during charging and discharging operations. Maximum efficiency was achieved with an airflow configuration provided from the bottom when charging at 0.955 kg/m 2 .s. Consequently, a sizable quantity of heat or energy (60 MJ) was retained. It was also observed that the relationship between air mass flow rate and particle size was significant, with smaller particles retaining more energy. When comparing bed 1 with bed 2 at this air mass flow rate, bed 1 stored 2.1 times more energy than bed 2. A wind tunnel experiment was used to measure the pressure drop in the packed rock bed. The pressure drop in the bed increases with an increase in particle Reynolds number and decreases with an increase in particle size. Rock bed heat transfer coefficient and Nusselt number were calculated using the correlation that has already been established in the literature smaller particles showed higher heat transfer coefficients and lower Nusselt numbers. This is due to the increase in particle‐to‐particle interaction and larger particle surface areas. For a given Reynolds number, the Nusselt number increases with the size of the rock particle.

Experimental Study on Storage Performance of Packed Bed Solar Thermal Energy Storage System Using Sintered Ore Particles

Experimental Study on Energy Storage Performances of Packed Bed with Different Solid Materials

Experimental study on storage performance of packed bed solar thermal energy storage system using steel slag

Experimental Study on Thermal Storage Performance of Rock Packed Bed

Dynamic Performances Of Solar Heat Storage System Using Packed Bed

A performance analysis of the spray-type packed bed thermal energy storage for concentrating solar power generation

Measurement and Analysis of Thermal Conductivity of Ceramic Particle Beds for Solar Thermal Energy Storage

Experimental Study of Thermal Energy Storage System for Solid Particles/ Heat Transfer Oil in Shell and Tube Heat Exchangers with H-shaped Fins

Dynamic Charging Performance of A Solar Latent Heat Storage Unit for Efficient Energy Utilization

Experimental Research of the Heat Transfer Characteristics Using A Packed-Bed of Honeycomb Ceramic for High Temperature Thermal Storage System

Performance analysis and system parameters optimization of a packed bed solar thermal energy storage having spherical packing elements with pores

Performance study of low temperature air heated rock bed thermal energy storage system

STUDY ON MEDIUM TEMPERATURE OF QUARTZ SAND AND STEEL SHOT SENSIBLE SOLAR THERMAL STORAGE AND OPTIMIZATION

Preliminary Component Design and Cost Estimation of a Novel Electric-Thermal Energy Storage System Using Solid Particles

Investigation on the Performance of a High-Temperature Packed Bed Latent Heat Thermal Energy Storage System Using Al-Si Alloy

Performance of Packed Bed Thermal Energy Storage with Cascaded Multiple Capsuled Phase Change Materials

A Comprehensive Investigation of the Mathematical Models for a Packed Bed Latent Heat Thermal Energy Storage System

Performance study of a packed bed in a closed loop thermal energy storage system

Thermal performance of a novel composite phase change material for solar-assisted air source heat pump packed bed thermal energy storage application

Heat transfer characteristics of the innovative spray-type packed bed thermal energy storage: An experimental study

Performance assessment of an oil-based packed bed thermal energy storage unit in a demonstration concentrated solar power plant