Abstract:The powertrain in combustion engine and electric vehicles requires a thermal management system to regulate the operating temperature of the under-hood components. The introduction of computer-controlled cooling system actuators (e.g., variable speed fans, pump, and valves) enables power savings over drive cycles. The radiator is typically sized for maximum heat rejection per environmental and vehicle thermal loading conditions. This paper explores the use of multiple radiators to adapt the cooling system operations to driving demands. A nonlinear multiple-input (i.e., fan array speed, pump, and outlet valve positions) thermal model is presented to predict system behavior. A stateflow controller has been designed and implemented to maintain the component temperature within a desired range (~80 °C). A series of experimental tests have been conducted to compare the proposed architecture’s performance against a single radiator design. A standard driving cycle featuring low (20 kW) and high (40 kW) heat loads was implemented in the laboratory for a vehicle starting from rest. The coolant temperature tracking, fan speeds, and fan power draw were studied over the representative operating cycle. The test results show a much faster warmup time (~10 min) and temperature tracking for the twin radiator experimental test as compared to the single radiator (~13 min). The net fan energy consumption was reduced by 4.6% with the twin radiator as opposed to the single-radiator configuration. Considering that engines usually operate at idle to medium loads, these findings can improve the powertrain’s overall performance.

Performance Simulation Analysis of Modular Heat Dissipation Unit

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

Water Cooling System Design and Thermal Analysis for Electrical Vehicle Driving Motors

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

Analytical Modeling of Forced-Air Cooling Heatsink by Considering Air Temperature Rise in Channel and Coupling of Multiple Heat Sources

Heat Dissipation Design of Sub-module in Modular Multilevel Converter

Numerical study of flow and heat transfer on construction machinery detached vehicular cooling system

Optimization of Motor Heat Dissipation Systems Based on Three Dimensional Flow Field Analysis

Simulation and Experimental Study on Thermal State of Engine Compartment of Commercial Vehicle

Multi-scale simulation and optimization on a thermal management system of intermediate circuit and experiment validation

Analytical Modeling of Air-Cooling System for Multiple Discrete Device Parallel Converter

Numerical Simulation Study on Thermal-Hydraulic Performances of Vehicular Radiator Heat Transfer Units

Experimental study of dual-cycle thermal management system for engineering radiator

Modelling and analysis of a liquid-cooled system for thermal management application of an electronic equipment

Modeling and Control of a Multiple-Heat-Exchanger Thermal Management System for Conventional and Hybrid Electric Vehicles

Performance Simulation Analysis of Composite Thermal Management System for Hypersonic Vehicle

Modeling and Simulation Analysis of Electric Vehicle Battery Cooling System

Simulation and analysis of a noval thermal management system integrated with heat pipe radiators for 4680 battery module

Structural design and thermal performance analysis of hybrid electric vehicle battery pack cooling system

Experiment and Simulation Research for Vehicle Engine Cooling Package

Simulation Analysis of New Energy Vehicle Engine Cooling System Based on K-E Turbulent Flow Mathematical Model