Abstract:A droplet impacting a solid surface undergoes deposition, splashing, or rebounding, depending on the properties of the droplet and impacted surface. The deposition pattern attracts lots of attention for the reasons of its predictable behavior on wetting and dewetting. The phenomenon of the central jet, even breaking up into a secondary droplet, is observed during gentle deposition on partially wettable surfaces. The mechanism behind the central jet is addressed by the dual role of the inertia force. In this paper, the dynamic characteristics of droplet deposition are analyzed with a focus on the receding process from jetting to secondary droplet emission. The jet is pinched off into a small secondary droplet when the impacting Weber (We) number is within the range of approximately 26-54. The secondary droplet is then ejected because of the collision with the upward jet. The convergence of capillary waves on the liquid film is employed to explain the two-stage upward jet. The jet tip is pinched off because of Rayleigh-Plateau instability, leading to the generation of the secondary droplet. A geometric model of a two-floor cylinder is further proposed to describe the equivalent recession of the capillary wave. The equivalent radius of the receding wave is linear with time, and the jet height exhibits a scaling law of Djet ∼ (t - 0.8)1/2 with normalized time. Additionally, the dynamic characteristics are investigated from time and size views. With various Weber numbers, the normalized receding, jetting, and tip times are found to remain almost constant. A piecewise relationship with the Weber number is revealed for the normalized receding wave and the tip height. The wave recedes at the characteristic velocity of 0.23 m/s. Moreover, the normalized jet height and tip diameter, as well as secondary droplet diameter, are independent of the inertia force. The emission velocity and kinetic energy of the secondary droplet are found to reach the maximum at We ∼ 41.6.

Viscous infuences on jetting process from an impacted concave free surface

Viscous influences on impulsively generated focused jets

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Liquid Jet Formation During a Suspended Liquid Suction Process

Jet Formation During the Gas Penetration Through a Thin Liquid Layer

Two jets during the impact of viscous droplets onto a less-viscous liquid pool

Asymmetric Jetting during the Impact of Liquid Drops on Superhydrophobic Concave Surfaces

Influence of Viscous Stability on Jet Interface by Dense Particles

Unsteady Numerical Investigation of Jet Influence on the Gas-Solid Crossflow in a Confined Domain

Experimental Investigation of Flow Dynamics of Sweeping Jets Impinging Upon Confined Concave Surfaces

Impact of a microfluidic jet onto a pendant droplet

Singular jets during droplet impact on superhydrophobic surfaces

Jet or wet? Droplet post-impact regimes on concave contours

Instability Analysis of the Cone–jet Flow in Liquid-Driven Flow Focusing

Experimental Investigation of Jet Influence on Gas-Solid the Two-Phase Crossflow in a Confined Domain

Impact of Liquid Crossflow on the Discharge Coefficient of a Gas Jet Hole on a Flat Plate

Interaction of liquid films formed by two continuous jets impinging obliquely on a vertical wall

Oblique Droplet Impact on Superhydrophobic Surfaces: Jets and Bubbles

Highly Viscous Microjet Generator

Receding Dynamics of Droplet Deposition on a Smooth Surface from a Central Jet to Secondary Droplet Emission

Interfacial Instability and Transition of Jetting and Dripping Modes in a Co-Flow Focusing Process