Abstract:This paper proposed a kind of guard traces based on a subwavelength periodic structure to reduce the far-end crosstalk (FEXT) of parallel microstrip lines in the PCB. This technology can be used to improve the false triggering and signal transmitting capacity of a multiconductor transmission line circuit system. In order to explore the present novel guard trace effect on isolating electromagnetic interference (EMI), the frequency response of the mutual capacitance and mutual inductance of the overall circuit system was provided and an equivalent circuit model was built. In comparison to the conventional microstrip line for isolating the EMI between parallel microstrip lines, the novel guard trace can efficiently reduce the mutual capacitance and mutual inductance of the overall circuit system. Thus, it is favorable for suppressing the crosstalk between microstrip lines. The $S$ -parameters calculation result showed that this kind of subwavelength periodic microstrip guard trace can isolate the EMI between two microstrip lines more effectively. Particularly, the conventional grounded guard trace needs a lot of dense grounded holes, which severely influences the wiring design of various layers of a multilayer circuit board. However, the proposed guard trace requires only one grounded hole, which has little influence on the circuit wiring of each layer of a multilayer printed circuit board. In our experiment, the step function signal of 30 ps rise time was imported into one microstrip line to measure the FEXT of the other microstrip line. It was demonstrated by the measurement result that the subwavelength periodic microstrip guard trace can reduce the FEXT to be below 5% of the transmission signal amplitude and is more flexible in practice. In compliance with the actual demand for a high-speed circuit, three isolation structures were proposed, and their isolation effects on the electromagnetic coupling between microstrip lines were verified individually.

Using Square Cross Structure for Far-End Crosstalk Reduction on Microstrip Signal Lines in DDR5

Far-End Crosstalk Mitigation for Microstrip Lines in High-Speed PCBs

Far-End Crosstalk Mitigation in DDR5 Using Graphene-Paraffin Material Coated Signal Lines with Tabs

FEXT Reduction Using Mushroom Structures Thickened Soldermask for DDR5 PCBs

Far-End Crosstalk Mitigation for Transmission Lines in DDR5 Using Glass-Weave Coating Structure

Far-End Crosstalk Mitigation Using Homogeneous Dielectric Substrate in DDR5

A Novel Dieletric Slot Stripline Structure for Millimeter Wave Flexible Printed Circuit

A Shielding Structure for Crosstalk Reduction in Silicon Interposer

Design and Simulation to Reduce the Crosstalk of Ultra-Fine Line Width/space in the Redistribution Layer

A Bit-Rearrangement Based Method to Reduce SSN of DDR Interface in STB Chip Design

Modeling and Measurement of A Novel Shielding Design in Silicon Interposer

Crosstalk Reduction in TSV Arrays with Direct Ohmic Contact Between Metal and Silicon-Substrate

Different designs of TSVs for 3D IC: Signal integrity analysis with cascaded scattering matrix

An Application of the Subwavelength Periodic Microstrip Guard Trace in High-Speed Circuits

Double-Shielded Interposer with Highly Doped Layers for High-Speed Signal Propagation

An Exhaustive Search Of The Optimal 6c Level Static Shielding Scheme For Rectangle Tsv Arrays

Analysis on the Effectiveness of the 20-H Rule Using Numerical Simulation Technique

Micro-strip line crosstalk based on multi-resolution time domain method

An Enhancement of Crosstalk Avoidance Code Based on Fibonacci Numeral System for Through Silicon Vias

A Crosstalk Avoidance Method Combining Crosstalk Avoidance Code with Shielding Wire Technique

Mosaic-3C1S: A Low Overhead Crosstalk Suppression Scheme for Rectangular TSV Array