Abstract:Purpose: To prospectively characterize and optimize radiofrequency energy deposition to determine ideal parameters for achieving large ablation zones. Materials and methods: An internally-cooled RF system was used to perform 214 ablations in 72 ex-vivo bovine livers. Tip exposure (1-5 cm), electrode current (400-2500 mA), and application duration (3-15 min) were systematically varied. A pulsing algorithm optimized efficiency of RF deposition, including initial automatic ramping followed by adjustment in current, in response to changes in tissue impedance. Following the procedure ablation diameter and length were measured, sphericity calculated, and correlated with parameters of energy deposition and tissue temperatures. Results: Increasing electrode exposure from 1-5 cm produced linear increases in ablation diameter from 1.4 ± 0.1 to 5.3 ± 0.1 cm (y = 1.1x-0.5; R2 = 0.93), and length (y = 1.18x + 0.34; R2 = 0.92). A sphericity index >0.85 was noted at optimal energy setting for electrode exposures of 1-4 cm. Maximum temperatures post-ablation increased with active tip length from 68.5 ± 4.9 °C to 91.3 ± 1.5 °C in a logarithmic (y = 0.94ln(x)-2.75; R2 = 0.90) or power relationship between temperature and the resultant ablation diameter (y = 0.27e0.0295x; R2 = 0.76). A tight exponential relationship (y = 0.28x0.38; R2 = 0.97) was also observed between total energy deposition and ablation diameter. Finally, a multifactor relationship of the diameter of ablation to electrode tip exposure and the time to first impedance rise was successfully modeled, with a root mean squared error of 1.9 mm and R2 = 0.95. Conclusion: Large, reproducible, and spherical ablation areas can be achieved with the novel system described, with efficient delivery of RF energy deposited into tissue. These findings may have important clinical relevance in regards to the clinical utility of RF ablation compared to other competitive forms of thermal tumor ablation.

Effect of Coolant Temperature on Lesion Size for Radiofrequency Ablation with Internally Cooled Probe

Finite Element Analysis on Lesion Size of Internal-cooled Radiofrequency Ablation

Influence of heat sink effect of radiofrequency ablation on temperature values in temperature field in vitro

Computer simulation study on the effect of electrode–tissue contact force on thermal lesion size in cardiac radiofrequency ablation

Evaluation of lesion characteristics and baseline impedance on high-power short-duration radiofrequency catheter ablation using computer simulation

Investigation of a Spherical-Section Ultrasound Phased Array for Hepatic Ablation

Optimization and characterization of a novel internally-cooled radiofrequency ablation system with optimized pulsing algorithm in an ex-vivo bovine liver

The Impact of Large Blood Vessel Location on Thermal Dose Distribution During Focused Ultrasound Surgery for Hepatic Tumor Ablation

Finite Element Analysis of Heat Lesions for Radio Frequency Atria Fibrillation Ablation

The effects of electrical and thermal boundary condition on the simulation of radiofrequency ablation of liver cancer for tumours located near to the liver boundary

Experimental Study of a Novel Radiofrequency Ablation System

Comparison of Two Techniques for Radiofrequency Hepatic Tumor Ablation through Numerical Simulation

Tuning the Pennes Perfusion Rate to Model Large Vessel Cooling Effects in Hepatic Radiofrequency Ablation

Effects of Large Blood Vessel Locations During High Intensity Focused Ultrasound Therapy for Hepatic Tumors: a Finite Element Study

Thermal and electric Characteristics of High-power Short-duration Radiofrequency Ablation and Standard Radiofrequency Ablation: A Computer Simulation Study

A New Model for RF Ablation Planning in Clinic.

Could it be advantageous to tune the temperature controller during radiofrequency ablation? A feasibility study using theoretical models

Assessing The Thermal Damage Induced By Radiofrequency Ablation for Localized Liver Cancer

Bicomponent Conformal Electrode for Radiofrequency Sequential Ablation and Circumferential Separation of Large Tumors in Solid Organs: Development and In Vitro Evaluation

An Analytical Solution for Temperature Distributions in Hepatic Radiofrequency Ablation Incorporating the Heat-Sink Effect of Large Vessels.

Radiofrequency ablation for liver tumors abutting complex blood vessel structures: treatment protocol optimization using response surface method and computer modeling