Abstract:In this work, thioacetamide (TA) is selected as a sulfur‐containing additive for the precursor solution used in the hydrothermal deposition of Sb2(S,Se)3. With the incorporation of TA, the formation of large voids within the Sb2(S,Se)3 absorber is suppressed, and deep‐level donor‐like defects such as sulfur vacancies are passivated, resulting in enhanced performance of Sb2(S,Se)3 solar cells. Antimony selenosulfide (Sb2(S,Se)3) has recently emerged as a promising light‐absorbing material, attributed to its tunable photovoltaic properties, low toxicity, and robust environmental stability. However, despite these advantages, the current record efficiency for Sb2(S,Se)3 solar cells significantly lags behind their Shockley–Queisser limit, especially when compared to other well‐established chalcogenide‐based thin‐film solar cells, such as CdTe and Cu(In,Ga)Se2. This underperformance primarily arises from the formation of unfavorable defects, predominately located at deep energy levels, which act as recombination centers, thereby limiting the potential for performance enhancement in Sb2(S,Se)3 solar cells. Specifically, deep‐level defects, such as sulfur vacancy (VS), have a lower formation energy, leading to severe non‐radiative recombination and compromising device performance. To address this challenge, thioacetamide (TA), a sulfur‐containing additive is introduced, into the precursor solution for the hydrothermal deposition of Sb2(S,Se)3. This results indicate that the incorporation of TA helps in passivating deep‐level defects such as sulfur vacancies and in suppressing the formation of large voids within the Sb2(S,Se)3 absorber. Consequently, Sb2(S,Se)3 solar cells, with reduced carrier recombination and improved film quality, achieved a power conversion efficiency of 9.04%, with notable improvements in open‐circuit voltage and fill factor. This work provides deeper insights into the passivation of deep‐level donor‐like VS defects through the incorporation of a sulfur‐containing additive, highlighting pathways to enhance the photovoltaic performance of Sb2(S,Se)3 solar cells.

Study of Defects in Sb2Se3 Solar Cells Via Admittance Spectroscopy

Investigation of electrically-active defects in Sb 2 Se 3 thin-film solar cells with up to 5.91% efficiency via admittance spectroscopy

Influence of S-content Ratios on the Defect Properties of Sb2(S , Se1–)3 Thin-Film Solar Cells

Distinctive Deep-Level Defects in Non-Stoichiometric Sb<sub>2</sub>Se<sub>3</sub> Photovoltaic Materials

Enhanced Sb2Se3 Solar Cell Performance Through Theory-Guided Defect Control

Experimental disclosing the composition- and structure-dependent deep-level defect in photovoltaic antimony trisulfide materials

Efficient defect passivation of Sb2Se3 film by tellurium doping for high performance solar cells

Defect control for high efficiency antimony selenosulfide solar cells by interface Engineering of buried monoatomic aluminum oxide layer

Importance of Interfacial Passivation in the High Efficiency of Sb2Se3 Thin-Film Solar Cells: Numerical Evidence

Electrical Activity of Defects in CdTe Solar Cells via Aberration-corrected STEM

Controlling Unintentional Defects Enables High‐Efficient Antimony Selenide Solar Cells

Active Passivation of Anion Vacancies in Antimony Selenide Film for Efficient Solar Cells

Crystal Growth Promotion and Defect Passivation by Hydrothermal and Selenized Deposition for Substrate-Structured Antimony Selenosulfide Solar Cells

Investigation of electronic transport mechanisms in Sb2Se3 thin-film solar cells

Thermally Driven Point Defect Transformation in Antimony Selenosulfide Photovoltaic Materials

Importance of Interfacial Passivation in the High Efficiency of Sb 2 Se 3 Thin-Film Solar Cells: Numerical Evidence

Deep Defects Limiting the Conversion Efficiency of Sb2Se3 Thin-Film Solar Cells.

Additive‐Assisted Hydrothermal Growth Enabling Defect Passivation and Void Remedy in Antimony Selenosulfide Solar Cells

Heterojunction Lithiation Engineering and Diffusion-Induced Defects Passivation for Highly Efficient Sb2(S,Se)3 Solar Cells

Probing the Trap States in N-i-P Sb2(S,Se)3 Solar Cells by Deep-Level Transient Spectroscopy.

Optimizing Crystal Orientation and Defect Mitigation in Antimony Selenide Thin-Film Solar Cells through Buffer Layer Energy Band Adjustment