Abstract:Due to the textures and flatness problems of the welding under test, the lift-off distance of the detection probe varies during test, which constitutes the main error source in the NDT system. An eddy current detection probe that is composed of a rectangular excitation coil and a giant magnetoresistance device has been designed. The simulation results show that the effect of lift-off changes caused by the welding seam would be reduced to minimal in the case of the axis of excitation coil perpendicular to the welding seam. In addition, it suggests that the eddy current induced by the dual frequency excitation signal provides more effective information on the welding defect. Therefore, for further understanding and interpretation of the dual frequency information, the independent component analysis method is employed. Under the control of field programmable gate arrays board and two stepper motors, a displacement platform that carried the detection probe scanned the surface of the welding pieces, i.e. two aluminum-alloy plates, in which the frequencies of 500 and 4000 Hz are applied. The experiment results show that the influence of lift-off caused by the unflatness of the two plates can be reduced and the defect of diameter smaller than 1mm can be detected, showing that the proposed method helps enhance system capability in identifying the buried small defect.

Research on Weld Defect Detection Based on Eddy Current Thermal Imaging

Weld Crack Detection Based on Region Electromagnetic Sensing Thermography

Non-destructive evaluation of weld defect with coating using electromagnetic induction thermography

Stainless Steel Weld Defect Detection Using Eddy Current Pulsed Thermography

Potential of Eddy Current Pulsed Thermography As a Nondestructive Testing Method

Eddy Current Testing On Weld Defect Based On The Dual Frequency Independent Component Analysis

Investigation of Remote Field Eddy Current Defect Detection for Pipeline Welds

Multiphysics Structured Eddy Current and Thermography Defects Diagnostics System in Moving Mode.

An Enhance Feature Algorithm for Defect Detection of Pneumatic Pressure Equipmentusing Eddy Current Pulsed Thermography

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

Research on Welding Residual Stress Measurement Using Electromagnetic Acoustic Transducer

Quantitative Surface Crack Evaluation Based on Eddy Current Pulsed Thermography

Research on Eddy Current Pulsed Thermography for Rolling Contact Fatigue Crack Detection and Quantification in Wheel Tread

Quantitative validation of Eddy current stimulated thermal features on surface crack

Heat Conduction Based Eddy Current Pulsed Thermography (ECPT) for Defect Evaluation

Improvement of Defect Feature Extraction in Eddy Current Pulsed Thermography.

Defect Automatic Identification of Eddy Current Pulsed Thermography

Research on Detection Mechanism of Weld Defects of Carbon Steel Plate Based on Orthogonal Axial Eddy Current Probe

Impact damage detection and characterization using eddy current pulsed thermography

Influence of Water Film on Subsurface Defect Detection Using Eddy Current Pulsed Thermography

Research on Pulsed Eddy Current Testing Technology for Cladding Pipeline