Abstract:Non-equiatomic high entropy alloys (HEAs) and medium entropy alloys (MEAs) are expected to have the potential to exhibit good mechanical properties due to abundant composition designs compared to equiatomic alloys. It has been reported that an equiatomic CoCrNi MEA shows better strength-ductility balance than CoCrFeMnNi HEA, and there is a possibility that the mechanical properties can be further improved by changing chemical composition. Among the constituent elements, cobalt (Co) has the effect of decreasing stacking fault energy (SFE). In this study, we clarified the effect of Co-content on mechanical properties of non-equiatomic Co–Cr–Ni MEAs with different amounts of Co through investigating deformation behaviors and deformation microstructures. Cox(CrNi)(100−x) (x = 20 (Co20), 40 (Co40), 60 (Co60) at%) MEAs were processed to very high plastic strains by high-pressure torsion (HPT) and subsequently annealed under proper conditions to obtain FCC single-phase and uniform fine grain sizes. Mechanical properties of the specimens with fully recrystallized microstructures were characterized by tensile tests at room temperature. Their deformed microstructures at different tensile strain levels were observed by electron microscopy. The result of the tensile tests showed that the work-hardening rate was enhanced with increasing the Co-content although early fracture before reaching plastic instability condition occurred in Co60. Planar slip of dislocations and deformation twinning were observed in Co20 (SFE = 30 mJ/m2), while, in addition to them, deformation-induced martensitic transformation to HCP ε-martensite was observed in Co40 having lower SFE (SFE = 10 mJ/m2), leading to higher work-hardening rate. By increasing Co-content (decreasing SFE) further, phase fraction of ε-martensite greatly increased in Co60 (SFE = 0 mJ/m2) compared with Co40, and early fracture occurred due to stress concentration at intersects between martensite and grain boundaries. The present results suggested that the mechanical properties of the present materials could be effectively designed by controlling the SFE.

Tailored tensile properties of CoCrNi medium entropy alloy by tuning the elemental distribution

Enhancing the Strength of AlCrFeNi HEAs Via Tailoring Aluminum Content and Optimal Aging Treatment

Dynamic deformation behaviors and mechanisms of CoCrFeNi high-entropy alloys

Enhanced strength-ductility synergy in a Ta-doped CoCrNi medium-entropy alloy with a dual heterogeneous structure

Design and Optimization of the Composition and Mechanical Properties for Non-Equiatomic CoCrNi Medium-Entropy Alloys

Plasticity Improvement in a Co-Rich Co<sub>40</sub>Fe<sub>25</sub>Cr<sub>20</sub>Ni<sub>15</sub> High-Entropy Alloy via Al Alloying

Dynamic tensile behavior of Al0.1CoCrFeNi high entropy alloy: Experiments, microstructure and modeling over a wide range of strain rates and temperatures

Molecular simulation of microstructure evolution and plastic deformation of nanocrystalline CoCrFeMnNi high-entropy alloy under tension and compression

Chemical-element-distribution-mediated Deformation Partitioning and Its Control Mechanical Behavior in High-Entropy Alloys

Effect of Cobalt-Content on Mechanical Properties of Non-Equiatomic Co–Cr–Ni Medium Entropy Alloys

Tensile mechanical properties of CoCrFeNiTiAl high entropy alloy via molecular dynamics simulations

Tensile deformation behavior and deformation twinning of an equimolar CoCrFeMnNi high-entropy alloy

Plasticity Improvement in a Co-Rich Co40Fe25Cr20Ni15 High-Entropy Alloy via Al Alloying

Tailoring nanoprecipitates to achieve ultrahigh strength (CoCrNi)94.5W3Ta2.5 medium-entropy alloys

Achieving excellent strength-ductility synergy via high density dislocation and nano-twinning in cryo-rolled FeCoCrNiMo0.2 high-entropy alloy

In-situ study of room temperature tensile deformation of a CrMnFeCoNi high-entropy alloy

Characteristic deformation microstructure evolution and deformation mechanisms in face-centered cubic high/medium entropy alloys

Achieving a unique combination of strength and ductility in CrCoNi medium-entropy alloy via heterogeneous gradient structure

Ductile CoCrFeNiMox High Entropy Alloys Strengthened by Hard Intermetallic Phases

Tensile Behavior of CoCrFeMnNi High-Entropy Alloy with Intermediate Strain Rate Included

The Effect of Cu and Mn Elements on the Mechanical Properties of Single-Crystal CoCrFeNi-based High-Entropy Alloy under Nanoindentation