Barium-doped Pr2Ni0.6Cu0.4O4+ with Triple Conducting Characteristics As Cathode for Intermediate Temperature Proton Conducting Solid Oxide Fuel Cell

Chengyi Ai,Tingting Li,Rongzheng Ren,Zhenhua Wang,Wang Sun,Jinsheng Feng,Kening Sun,Jinshuo Qiao
DOI: https://doi.org/10.1016/j.cjche.2021.09.010
2021-01-01
Abstract:Proton conducting solid oxide fuel cell (H-SOFC) is an emerging energy conversion device, with lower activation energy and higher energy utilization efficiency. However, the deficiency of highly active cathode materials still remains a major challenge for the development of H-SOFC. Therefore, in this work, K2NiF4-type cathode materials Pr2-xBaxNi0.6Cu0.4O4+delta (x = 0, 0.1, 0.2, 0.3), single-phase tripleconducting (e /O-2 /H+) oxides, are prepared for intermediate temperature H-SOFCs and exhibit good oxygen reduction reaction activity. The investigation demonstrates that doping Ba into Pr2-xBaxNi0.6Cu0.4O4+delta can increase its electrochemical performance through enhancing electrical conductivity, oxygen vacancy concentration and proton conductivity. EIS tests are carried at 750 degrees C and the minimum polarization impedances are obtained when x = 0.2, which are 0.068 Omega.cm(2) in air and 1.336 Omega.cm(2) in wet argon, respectively. The peak power density of the cell with Pr1.8Ba0.2Ni0.6Cu0.4O4+delta cathode is 298 mW.cm(-2) at 750 degrees C in air with humidified hydrogen as fuel. Based on the above results, Ba-doped Pr2-xBaxNi0.6Cu0.4O4+delta can be a good candidate material for SOFC cathode applications. (C) 2021 The Chemical Industry and Engineering Society of China, and Chemical Industry Press Co., Ltd. All rights reserved.
What problem does this paper attempt to address?