Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

Analytic Model of Dual-Layer-Structure MEMS Thermal Wind Sensor with Increased Sensitivity

An Efficient Macromodel Extraction Strategy for Packaged MEMS Thermal Wind Sensor Considering Multiphysics

An efficient macro model for CMOS-MEMS thermal wind speed sensor

Temperature Drift Compensation of a Tuned Low Stiffness MEMS Accelerometer Based on Double-Sided Parallel Plates

Research on Dust Effect for MEMS Thermal Wind Sensors

High Accuracy and Miniature 2-D Wind Sensor for Boundary Layer Meteorological Observation

Fabrication and characterization of high-sensitivity, wide-range, and flexible MEMS thermal flow velocity sensors

Experiments and simulations of MEMS thermal sensors for wall shear-stress measurements in aerodynamic control applications

Two Capacitive Micro-Machined Ultrasonic Transducers for Wind Speed Measurement

Modeling and Analysis of MEMS Capacitive Pressure Sensors with Vertical Comb Fingers

Resonance-State Temperature Compensation Method for Ultrasonic Resonance Wind Speed and Direction Sensors

Development of a six-axis force/moment sensor for wind tunnel model test

3D Numerical Simulation and Structural Optimization for a MEMS Skin Friction Sensor in Hypersonic Flow

Thermal Drift Analysis Using a Multiphysics Model of Bulk Silicon MEMS Capacitive Accelerometer

Integrated Amorphous Carbon Film Temperature Sensor with Silicon Accelerometer into MEMS Sensor

A MEMS Resonant Differential Pressure Sensor With High Accuracy by Integrated Temperature Sensor and Static Pressure Sensor

Fabrication and Characterization of a MEMS Thermal Convective Accelerometer on Silicon-in-Glass Substrate

High Performance Bidirectional Thermal Gas Flow Sensor of (100) Silicon Single-Sided Fabrication by 45-Tilted Dicing

Wearable Anemometer with Multi-Sensing of Wind Absolute Orientation, Wind Speed, Attitude, and Heading

A Theoretical Study on MEMS-Based Thermal Conductivity Sensor

Development of Highly Sensitive and Thermostable Microelectromechanical System Pressure Sensor Based on Array-Type Aluminum–Silicon Hybrid Structures