Abstract:As an advanced connection technology for large thick-walled components, narrow gap laser welding has the advantages of small heat input and high efficiency and quality. However, porosity defects are prone to occur inside the weld due to the complex welding environment. In this study, the influence of the process parameters and pollutants such as water and oil on the porosity defect were explored. The action mechanism of water on the electron temperature and spectral intensity of the laser-induced plasma was analyzed. The results showed that the spectral intensity during narrow gap laser welding was weaker than that of flat plate butt welding. Under the optimal welding process conditions, the electron temperature during narrow gap laser self-fusion welding was calculated as 7413.3 K by the Boltzmann plot method. The electron density was 5.6714 × 1015 cm−3, conforming to the thermodynamic equilibrium state. With six groups of self-fusion welding parameters, only sporadic porosity defects were observed according to the X-ray detection. When there was water on the base metal surface, a large number of dense pores were observed on the weld surface and in the weld through X-ray inspection. Compared with the spectral data obtained under the normal process, the relative light intensity of the spectrometer in the whole band was reduced. The electron temperature decreased to the range of 6900 to 7200 K, while the electron density increased. The spectrum variation during narrow gap laser wire filling welding was basically the same as that of laser self-fusion welding. The porosity defects caused by water and oil pollutants in the laser welding could be effectively identified based on the intensity of the Fe I spectral lines.

Development of a Low-Cost Arc Spectrum Sensor for Monitoring Pore Defects in Welding Process

Online Defect Detection of Al Alloy in Arc Welding Based on Feature Extraction of Arc Spectroscopy Signal

On-line monitor of hydrogen porosity based on arc spectral information in Al–Mg alloy pulsed gas tungsten arc welding

Real-time monitoring and control of porosity defects during arc welding of aluminum alloys

Real-time Defect Detection in Pulsed GTAW of Al Alloys Through On-Line Spectroscopy

A weld defects detection system based on a spectrometer

Transactions on Intelligent Welding Manufacturing: Volume III No. 3 2019

Study of Inner Porosity Detection for Al-Mg Alloy in Arc Welding Through On-Line Optical Spectroscopy: Correlation and Feature Reduction

The Review of Spectrum Detection and Ultrasonic Vibration Control of Porosity Defects in Aluminum Alloy Welding

Visual Sensing Systems for Arc Welding Process

A Study on Porosity in Gas Tungsten Arc Welded Aluminum Alloys Using Spectral Analysis

Online Welding Quality Monitoring Based on Feature Extraction of Arc Voltage Signal

Study on welding phenomena observation method based on arc and molten pool light emission characteristics in visible and infrared wavelength region – development of image sensing technology for in-process welding monitoring technology

Open source arc analyzer: Multi-sensor monitoring of wire arc additive manufacturing

EMD-based Pulsed TIG Welding Process Porosity Defect Detection and Defect Diagnosis Using GA-SVM

A Detailed Analysis of Welding Arc Spectrum Distribution Characteristics to Choose Light Sources of Laser Sensors

On-Line Detection of Porosity in Gas Tungsten Arc Welding of Aluminum Alloy Based on Spectrum Features

The Method and Experiment of Detecting the Strength of Structural Components Utilizing the Distributed Strain of Sensing Optical Fibers Demodulated by OFDR

Multisensor-Based Real-Time Quality Monitoring by Means of Feature Extraction, Selection and Modeling for Al Alloy in Arc Welding

Feasibility study of imaging spectroscopy to monitor the quality of online welding

Study on Porosity Defect Detection in Narrow Gap Laser Welding Based on Spectral Diagnosis