Abstract:Inner porosity of aluminum alloy in arc welding is usually invisible, transient and difficult to detect in real-time with weak physical information. This study investigated the key technologies for on-line inner porosity detection for aluminum-magnesium (Al-Mg) alloy in pulsed gas tungsten arc welding (GTAW) using arc optical spectroscopy and post-micro-characterization. A monitoring system for robotic GTAW was developed using a spectrometer, charge-coupled device camera, and microphone. Experiments for different degrees of porosity were designed before post-testing and microscopic characterization using scanning electron microscopy and energy dispersive spectroscopy. Two types of generation mechanism of inner porosity were discovered for Al alloy in GTAW. The line spectrums of metal and hydrogen components were selected before feature extraction by means of principal component analysis of optical spectroscopy. The correlation between the principal component coefficient of line spectrums (H I and Mg I) and inner porosity was quantitatively investigated using statistical values. Then, an improved feature parameter, e.g., the absolute coefficient of the H I spectrum from the first principal component, for inner porosity detection was proposed and experimentally validated at different levels of porosity. Finally, feature reduction and visualization were achieved by means of the proposed principal component analysis and t-Distributed Stochastic Neighbor Embedding. The correlation between microscopic analysis and spectrum features is also discussed.

Real-time Defect Detection in Pulsed GTAW of Al Alloys Through On-Line Spectroscopy

Online Defect Detection of Al Alloy in Arc Welding Based on Feature Extraction of Arc Spectroscopy Signal

Real-time Seam Defect Identification for Al Alloys in Robotic Arc Welding Using Optical Spectroscopy and Integrating Learning

EMD-based Pulsed TIG Welding Process Porosity Defect Detection and Defect Diagnosis Using GA-SVM

A weld defects detection system based on a spectrometer

Online Welding Quality Monitoring Based on Feature Extraction of Arc Voltage Signal

An Easy Method of Image Feature Extraction for Real-Time Welding Defects Detection

Porosity Detection in Pulsed GTA Welding of 5A06 Al Alloy Through Spectral Analysis

Real-Time Measurement of Seam Strength Using Optical Spectroscopy for Al–Li Alloy in Laser Beam Welding

On-line monitor of hydrogen porosity based on arc spectral information in Al–Mg alloy pulsed gas tungsten arc welding

Multisensor-Based Real-Time Quality Monitoring by Means of Feature Extraction, Selection and Modeling for Al Alloy in Arc Welding

On-Line Detection of Porosity in Gas Tungsten Arc Welding of Aluminum Alloy Based on Spectrum Features

Features Detection of Al Alloy Porosity During GTAW Process Based on Arc Spectrum and Improved Porosity-Focus Decision Tree

Study of Inner Porosity Detection for Al-Mg Alloy in Arc Welding Through On-Line Optical Spectroscopy: Correlation and Feature Reduction

Real-time Seam Penetration Identification in Arc Welding Based on Fusion of Sound, Voltage and Spectrum Signals

Spectral Diagnosis and Defects Prediction Based on ELM During the GTAW of Al Alloys

Real-time monitoring and control of porosity defects during arc welding of aluminum alloys

Investigation of Porosity in Pulsed GTAW of Aluminum Alloys Based on Spectral and X-ray Image Analyses

Feature Extraction and Modeling of Welding Quality Monitoring in Pulsed Gas Touch Argon Welding Based on Arc Voltage Signal

Development of a Low-Cost Arc Spectrum Sensor for Monitoring Pore Defects in Welding Process

Review on Multi-Information Acquisition, Defect Prediction and Quality Control of Aluminum Alloy GTAW Process