Abstract:The hypercompressor is one of the core facilities in low density polyethylene production, with a discharge pressure of approximately 300 MPa. A packing cup is the basic unit of cylinder packing, assembled by the interference fit between an inner cup and an outer cup. Because the shrink-fitting prestresses the packing cup, serious design is needed to gain a favorable stress state, for example, a tri-axial compressive stress state. The traditional method of designing the interference fit value for packing cups depends on the shrink-fit theory for thick-walled cylinder subject to internal and external pressure. According to the traditional method, critical points are at the inner radii of the inner and external cup. In this study, the finite element method (FEM) has been implemented to determine a more accurate stress level of packing cups. Different critical points have been found at the edge of lapped sealing surfaces between two adjacent packing cups. The maximum Von Mises equivalent stress in a packing cup increases after a decline with the rise of the interference fit value. The maximum equivalent stress initially occurs at the bore of the inner cup, then at the edge of lapped mating surfaces, and finally at the bore of the outer cup, as the interference radius increases. The traditional method neglects the influence of axial preloading on the interference mating pressure. As a result, it predicts a lower equivalent stress at the bore of the external cup. A higher interference fit value accepted by the traditional method may not be feasible as it might already make packing cups yield at the edge of mating surfaces or the bore of the external cup. Along with fatigue analysis, the feasible range of interference fit value has been modified by utilizing FEM. The modified range tends to be narrower and safer than the one derived from the traditional method, after getting rid of shrink-fit values that could result in yielding in a real packing cup.

Design and Finite Element Analysis of Composite PTFE Compression Packing with C-shape Structure

Experimental Research and Finite Element Analysis of Seals in the Pressure Compensator

Characteristics and mechanisms of turboshaft engine axial compressor casing containment

Tribological Properties of Seals in Integrated Transmission of Vehicle

Design of Pneumatic Parachute-Packing Machine

Study and analysis of mechanism structure test of metal packer

Experimental Study on Frictional and Sealing Performances of Packing Rings in an Oil-Free Gas Compressor

Design of Packing Cup Interference Fit Value of Hypercompressors for Low Density Polyethylene Production

Mechanical Behavior and Structure Optimization of Compressed PHP Packer Rubber

Finite Element Analysis of Reciprocating Sealing Component of Radial Single-piston Pump

Frictional Behavior Investigation on Three Types of PTFE Composites under Oil‐free Sliding Conditions

Research and Design of Packing of High Pressure CO2 Compressors

Modeling and Simulation of Wear in PTFE Lip Seals

Development of Rubber Packing Element for 105 MPa/215 °C Deep-Well Test Packer

Adaptability of hydraulic fracturing packers and optimization of their sealing performance for three common clastic rock reservoirs based on finite element analysis

Experimental investigation on frictional behavior and sealing performance of different composites for seal application

Friction and Wear Behaviors of PTFE-based Composites Filled with Polymers

Interfacial friction effects on sealing performances of elastomer packer

Molecular Dynamics Simulation and Finite Element Method Investigation of PTFE/carbon Fiber Composite Tribological Properties

Fluid-solid Coupling Analysis of the Pressure Expansion of Packers

Design Method of Interference Fit in Packing Cups of Hypercompressors