Abstract:Instead of the capillary plasma generator（CPG）,a discharge rod plasma generator（DRPG）is used in the30 mm electrothermal-chemical（ETC）gun to improve the ignition uniformity of the solid propellant.An axisymmetric two-dimensional interior ballistics model of the solid propellant ETC gun（2D-IB-SPETCG）is presented to describe the process of the ETC launch.Both calculated pressure and projectile muzzle velocity accord well with the experimental results.The feasibility of the 2D-IB-SPETCG model is proved.Depending on the experimental data and initial parameters,detailed distribution of the ballistics parameters can be simulated.With the distribution of pressure and temperature of the gas phase and the propellant,the influence of plasma during the ignition process can be analyzed.Because of the radial flowing plasma,the propellant in the area of the DRPG is ignited within 0.01 ms,while all propellant in the chamber is ignited within 0.09 ms.The radial ignition delay time is much less than the axial delay time.During the ignition process,the radial pressure difference is less than 5 MPa at the place 0.025 m away from the breech.The radial ignition uniformity is proved.The temperature of the gas increases from several thousand K（conventional ignition）to several ten thousand K（plasma ignition）.Compare the distribution of the density and temperature of the gas,we know that low density and high temperature gas appears near the exits of the DRPG,while high density and low temperature gas appears at the wall near the breech.The simulation of the 2D-IB-SPETCG model is an effective way to investigate the interior ballistics process of the ETC launch.The 2D-IB-SPETC model can be used for prediction and improvement of experiments.

Firing Range Optimization of a 155mm Uni-Modular Charge Howitzer by ETC Technology

Applied Analysis of Electrothermal Chemical Launch Technology in 155mm Modular Charge Howitzer

Application of Transient Burning Rate Model of Solid Propellant in Electrothermal-Chemical Launch Simulation

Numerical simulation and optimized design of a launching system with a novel charge structure

Simulation of Two-Dimensional Interior Ballistics Model of Solid Propellant Electrothermalchemical Launch with Discharge Rod Plasma Generator

A parametric study for an electrothermal-chemical artillery weapon

Electrical and Optical Test of a Semi-Combustible Plasma Generator Via a Plasma Ignition Simulator

Simulation of fire density of gatling gun shooting on light tripod

Vibration reduction performance of an arc tripod structure for firing accuracy improvement

Study on unsteady combustion and propelling mechanism of modular charge based on Euler–Lagrange method

Simulation of Two-Dimensional Interior Ballistics Model of Solid Propellant Electrothermal-Chemical Launch with Discharge Rod Plasma Generator

Numerical Simulation on the Pressure Wave in a 30MM Electrothermal-Chemical Gun with the Discharge Rod Plasma Generator

Study on the coupling calculation method for the launch dynamics of a self-propelled artillery multibody system considering engraving process

Optimization Design of Propellant Charge for a Medium and Large Caliber High Chamber Pressure Gun

Interior ballistic two-phase flow model and its calculation for a mixed charge structure

Modeling and Simulation on Launch of New Type Artillery

Key technologies of dynamic simulation and design for large caliber truck-mounted artillery

Modelling and Production of artillery firing-tables: case-study

Optimization of EM railgun based on orthogonal design method and harmony search algorithm

Optimization of Electromagnetic Railgun Based on Orthogonal Design Method and Harmony Search Algorithm

Monte-Carlo Based Lateral Thruster Parameters Optimization for 122 mm Rocket