Abstract:High-resolution and multichannel time-to-digital converters (TDCs) are needed in many electrical application systems. A new multistep fine time measurement method is proposed in this work, which is based on the delay-adjustable looped carry chains to obtain both high resolution and measurement precision. Each sub-step of the fine time measurement is assigned with a different measurement resolution in the descending order by dynamically configuring the delay line length. The time residue to be measured in the following sub-step becomes smaller, so that a finer resolution can be chosen. The overall oscillation number is the summation of the oscillation number of each sub-steps. The resolution of the TDC is determined by the last sub-step. So both high-resolution and small oscillation number (corresponding to high measurement precision) can be obtained. The TDC circuit was implemented on Stratix III field programmable gate array (FPGA) chip. Test results showed that the obtained resolution was less than 10 ps, and the measurement precision root mean square (rms) was about 13 ps. The differential nonlinearity (DNL) error and the integral nonlinearity (INL) error were in the range of −1 least significant bit (LSB) to 1 LSB without any bin calibration. The resource cost per TDC channel includes the lookup table (LUT) cost of 1064 and register cost of 318. The obtained TDC is comprehensively good considering its low resource cost and high linearity, and it is promising for multichannel TDC design.

A high precision TDC design based on FPGA+ARM

A High Precision Time-to-Digital Converter based on Multi-chain Interpolation with a Low Cost Artix-7 FPGA

A High-Throughput Vernier Time-to-Digital Converter on FPGAs with Improved Resolution Using a Bi-Time Interpolation Scheme

A Low-Cost FPGA-Based Coarse-Fine Counting Time-to-Digital Converter With External High-Precision Reference Clock

A High Resolution Time-to-digital-convertor Based on a Carry-Chain and DSP48E1 Adders in a 28-Nm Field-Programmable-gate-array

A High-Resolution Tdc Implemented In A 90nm Process Fpga

A High Precision Time-To-Digital Converter Based on Multi-Phase Clock Implemented Within Field-Programmable-Gate-Array

Design and Realization of High Precision Time-interval Measurement Based on FPGA

A High-Resolution TDC Design Based on Multistep Fine Time Measurement by Utilizing Delay-Adjustable Looped Carry Chains on FPGAs

A 5.5 ps Time-interval RMS Precision Time-to-Digital Convertor Implemented in Intel Arria 10 FPGA

A Flexible 32-Channel Time-To-Digital Converter Implemented in A Xilinx Zynq-7000 Field Programmable Gate Array

Design of Time Digital Converter Based on FPGA

Implementation of a High Precision Multi-Measurement Time-to-digital Convertor on a Kintex-7 FPGA

High-Resolution, Multi-Channel FPGA-Based Time-to-Digital Converter

A 1.15-Ps Bin Size and 3.5-Ps Single-Shot Precision Time-to-Digital Converter with On-Board Offset Correction in an FPGA

A 56-ps multi-phase clock time-to-digital convertor based on Artix-7 FPGA

Design of a high-precision time-to-digital converter in an Elitestek Ti60 field-programmable-gate-array

A 16-Channel 15 Ps TDC Implemented in a 65 Nm FPGA

Low-cost FPGA-based multi-channel TDC with high resolution and density for time-of-flight detectors

TDC Implementation Based on Internal Delay Module of FPGA

A ring-oscillator based multi-mode time-to-digital converter on Xilinx Kintex-7 FPGA