Abstract:Compared to many other characteristics of Li-ion batteries, the safety behavior is a critical property and should be examined carefully. Especially manufacturers and most studies only focus on the safety of pristine cells. However, the safety behavior can drastically change dependent on the prior aging conditions such as ambient temperature. Especially low temperature aged cells with Li plating show a drastically decreased safety behavior [1]. Moreover, cells aged at higher temperatures with a distinct solid-electrolyte-interface (SEI) layer on the anode show an increased onset of self-heating leading to improved safety [2]. Post-Mortem analysis of aged cells confirmed the two dominating aging mechanisms: Li plating and SEI growth for low and high temperature range, respectively. Heat-wait-seek (HWS) tests under quasi-adiabatic conditions in an accelerated rate calorimeter (ARC) are a well-known method to evaluate the safety behavior of Li-ion batteries and can reveal critical temperatures such as the onset of self-heating. HWS tests on cells aged at different temperatures until different state-of-health (SOH) reveal the trend that a more pronounced aging increases or decreases the onset of self-heating depending on whether SEI growth or Li plating is the dominating aging mechanism. In addition to the temperature measurement, multiple sensors for voltage, resistance, strain, and ultrasonic transmission and reflection were placed on the pouch cell for a better understanding of the ongoing processes while the HWS tests. The benefit of these sensors is that they are cheap, allowing them to be widely implemented. Furthermore, an externally coupled mass spectrometer provides information about the gases produced and released after venting of the cell [3]. By Correlating different sensors signals, critical events on the way to the thermal runaway can be reliably identified or even predict in an early stage. Hence, the HWS tests on Li-ion batteries aged at different temperatures in combination with the multi sensor study provide a comprehensive understanding of the influence of temperature dependent aging state on the safety behavior of Li-ion pouch cells. Acknowledgment We gratefully acknowledge the German Federal Ministry of Education and Research (BMBF) for the financial support of the projects AnaLiBa (03XP0347C) and MiCha (03XP0317C) within the AQua cluster. References [1] T. Waldmann, M. Wohlfahrt-Mehrens, Electrochimica Acta 230 (2017) 454–460. https://doi.org/10.1016/j.electacta.2017.02.036. [2] M. Börner, A. Friesen, M. Grützke, Y.P. Stenzel, G. Brunklaus, J. Haetge, S. Nowak, F.M. Schappacher, M. Winter, Journal of Power Sources 342 (2017) 382–392. https://doi.org/10.1016/j.jpowsour.2016.12.041. [3] A.A. Abd‐El‐Latif, P. Sichler, M. Kasper, T. Waldmann, M. Wohlfahrt‐Mehrens, Batteries & Supercaps 4 (2021) 1135–1144. https://doi.org/10.1002/batt.202100023. Figure 1

The Comparison of Thermal Stability and Safety Between Fresh and Aging Large Capacity Lithium Ion Battery with Silicon Carbon Anode

A Comparative Investigation of Aging Effects on Thermal Runaway Behavior of Lithium-Ion Batteries

Simulation Study on Thermal Runaway of Lithiumion Batteries in Different Aging States

Interface Engineering to Boost Thermal Safety of Microsized Silicon Anodes in Lithium-Ion Batteries

Electrochemical and Thermal Features of Aging Lithium-Ion Batteries Cycled at Various Current Rates

Influence of Aging Paths on the Thermal Runaway Features of Lithium-Ion Batteries in Accelerating Rate Calorimetry Tests

High-Safety Lithium-Ion Batteries with Silicon-Based Anodes Enabled by Electrolyte Design

Effects of Main Aging Mechanism and State of Charge on the Safety of 21700 Li-Ion Battery Cells with Ni-Rich NMC Cathode

Unraveling the Complex Temperature-Dependent Performance and Degradation of Li-Ion Batteries with Silicon-Graphite Composite Anodes

Comparative Study on Aging and Thermal Runaway of Commercial LiFePO4/graphite Battery Undergoing Slight Overcharge Cycling

Comparative Studies of Electrochemical Behavior of Silicon Anode Active Materials for High-Energy Lithium-Ion Batteries

Study on the temperature rise characteristics of aging lithium-ion batteries under different cooling methods

Lifetime Optimization of Amorphous Silicon Thin-Film Anodes for Lithium-Ion Batteries

The Evolution of Lithium-Ion Cell Thermal Safety with Aging Examined in a Battery Testing Calorimeter

Si-Based Anodes: Advances and Challenges in Li-Ion Batteries for Enhanced Stability

Thermal Safety Evaluation of Silane Polymer Compounds as Electrolyte Additives for Silicon-Based Anode Lithium-Ion Batteries

Internal short circuit and thermal runaway evolution mechanism of fresh and retired lithium-ion batteries with LiFePO4 cathode during overcharge

High-Temperature Storage Deterioration Mechanism of Cylindrical 21700-Type Batteries Using Ni-Rich Cathodes under Different SOCs

Probing the Reactivity of the Active Material of a Li-Ion Silicon Anode with Common Battery Solvents

Safety Evaluation of Temperature-Dependent Aging Mechanisms of Li-Ion Batteries Using ARC Tests with Multiple Online Sensors

Comprehensive Analysis on Aging Behavior and Safety Performance of LiNixCoyMnzO2/graphite Batteries after Slight Over-Discharge Cycle