Abstract:Measurements of gas/particle partition coefficients for semivolatile organic compounds (SVOCs) using filter-sorbent samplers can be biased if a fraction of gas-phase mass is measured erroneously as particle-phase due to sorption of SVOC gases to the filter, or, if a fraction of particle-phase mass is measured erroneously as gas-phase due to penetration of particles into the sorbent. A fundamental mechanistic model to characterize the air sampling process with filter-sorbent samplers for SVOCs was developed and partially validated. The potential sampling artifacts associated with measurements of gas-particle partitioning were examined for 19 SVOCs. Positive sampling bias (i.e., overestimation of gas/particle partition coefficients) was observed for almost all the SVOCs. For certain compounds, the measured partition coefficient was several orders of magnitude greater than the presumed value. It was found that the sampling artifacts can be ignored when the value of log[Kf/(Kp⋅Cp,a)] is less than 7. By normalizing the model, general factors that influence the sampling artifacts were investigated. Correlations were obtained between the dimensionless time required for the gas-phase SVOCs within the filter to reach steady state (Ts,s∗) and the chemical Vp values, which can be used to estimate appropriate sampling time. The potential errors between measured and actual gas/particle partition coefficients of SVOCs as a function of sampling velocity and time were calculated and plotted for a range of SVOCs (vapor pressures: 10−8 ∼ 10−3 Pa). These plots were useful in identifying bias from the sampling in previously-completed field measurements. Penetration of particles into the sorbent may result in significant underestimation of the partition coefficient for particles in the size range between 10 nm and 2 μm. For most of the selected compounds, backup filters can be used to correct artifacts effectively. However, for some compounds with very low vapor pressure, the artifacts remained or became even larger than they were without the backup filter. Thus, the option of backup filters must be considered carefully in field measurements of the gas/particle partitioning of SVOCs. The results of this work will allow researchers to predict potential artifacts associated with SVOC gas/particle partitioning as functions of compounds, the concentration of particles, the distribution of particle sizes, sampling velocity, and sampling time.

A Mass Transfer Model to Predict the Performance of Tube-type Passive Samplers for Exposure Determination of Volatile Organic Compounds

A model of passive diffusive sampler for determining indoor voc exposure

Use of Reference Chemicals to Determine Passive Uptake Rates of Common Indoor Air Vocs by Collocation Deployment of Active and Passive Samplers

Impacts of Sampling-Tube Loss on Quantitative Analysis of Gaseous Semi-Volatile Organic Compounds (svocs) Using an SPME-based Active Sampler.

A Mass Transfer Model for Simulating VOC Sorption on Building Materials

Transient Method for Determining Indoor Chemical Concentrations Based on Spme: Model Development and Calibration

A Multiscale Method for Predicting the Long-Term Emission Behaviors of Semivolatile Organic Compounds

A Review Of Mass-Transfer Models And Mechanistic Studies Of Semi-Volatile Organic Compounds In Indoor Environments

CAN WE USE VOC DIFFUSION COEFFICIENTS IN AIR FOR ESTIMATING THE UPTAKE RATE OF PASSIVE VOC SAMPLERS FOR LARGE SCALE INDOOR AIR SURVEYS?

Passive Sampler Exchange Kinetics in Large and Small Water Volumes Under Mixed Rate Control by Sorbent and Water Boundary Layer

An improved mass transfer based model for analyzing VOC emissions from building materials

Modeling volatile organic compounds sorption on dry building materials using double-exponential model

Steady-state model for predicting size-resolved gas-particle partitioning of semi-volatile organic compounds (SVOCs) in indoor environments

Simplified methods for characterizing dynamic sorption of SVOCs on viscous particles

A mass transfer model for simulating volatile organic compound emissions from ‘wet’ coating materials applied to absorptive substrates

A comparison of mathematical model formulations for organic vapor transport in porous media

General Analytical Mass Transfer Model for VOC Emissions from Multi-Layer Dry Building Materials with Internal Chemical Reactions

Evaluation of a New Passive Sampler Using Hydrophobic Zeolites As Adsorbents for Exposure Measurement of Indoor BTX

Prediction Model for SVOCs Transport in the Air and Interactions with Airborne Particles

Lattice Boltzmann Method Simulation of SVOC Mass Transfer with Particle Suspensions

Modeling and analysis of sampling artifacts in measurements of gas-particle partitioning of semivolatile organic contaminants using filter-sorbent samplers