Abstract:Vapor intrusion of toxic volatile organic compounds (VOCs) from subsurface soil vapor, through a building slab/floor, and into the indoor air is an important environmental contaminant transport mechanism. It is widely believed that advective flow, driven by the pressure differential between the subslab and indoor air, is the primary mechanism of subslab soil vapor entry into buildings. This paper explores the hypothesis that molecular diffusion through the slab may potentially play a larger role in vapor intrusion than previously believed and may even be the predominant vapor intrusion mechanism when the subslab vapor source strength is sufficiently high or the pressure differential is relatively low. A novel sampling device, referred to as a Passive Adsorptive Diffusion Sampler (PADS), is presented for the purpose of directly measuring the diffusion of VOCs through a building slab. A vacant warehouse was identified as a case study site where historical sampling had determined that vapor intrusion of trichloroethene (TCE) was adversely impacting the indoor air. Calculations using Fick's First Law of Diffusion are presented which demonstrate that diffusion alone can theoretically account for all the TCE observed in the indoor air at this building based on an effective diffusion coefficient for concrete that was calculated from the Johnson and Ettinger Model. Two groups of nine replicate PADS were deployed at two areas on the slab and used to measure the flux and effective diffusion coefficient at each of the 18 total points, which showed an order of magnitude variability within each area and over two orders of magnitude variability overall. These results indicate that diffusion through concrete is inherently variable when measured at a sub‐meter scale. However, when combined over both areas, the overall average approached that calculated from the Johnson and Ettinger Model. An additional 12 PADS were deployed across the building slab (for a total of 30) to quantify the overall building‐wide diffusive flux. This area‐weighted average diffusive flux was consistent with the predicted diffusive flux as calculated from Fick's First Law and the vapor intrusion mass input required to achieve the observed indoor air TCE concentration. The results of this study show that PADS provides a simple way to measure diffusive flux directly without having to drill through the slab. However, significant variability in the measured flux should be expected and will need to be accounted for by the inclusion of a relatively large number of samples including replicates. When using PADs at a new site, the collection of traditional subslab vapors at a select number of locations is recommended for the verification of a building‐specific effective diffusion coefficient, which may not necessarily be the same as for this building.

A model of passive diffusive sampler for determining indoor voc exposure

A Mass Transfer Model to Predict the Performance of Tube-type Passive Samplers for Exposure Determination of Volatile Organic Compounds

Evaluation of a New Passive Sampler Using Hydrophobic Zeolites As Adsorbents for Exposure Measurement of Indoor BTX

Transient Method for Determining Indoor Chemical Concentrations Based on Spme: Model Development and Calibration

Use of Reference Chemicals to Determine Passive Uptake Rates of Common Indoor Air Vocs by Collocation Deployment of Active and Passive Samplers

Quantitative Analysis of Indoor Gaseous Semi-Volatile Organic Compounds Using Solid-Phase Microextraction: Active Sampling and Calibration

CAN WE USE VOC DIFFUSION COEFFICIENTS IN AIR FOR ESTIMATING THE UPTAKE RATE OF PASSIVE VOC SAMPLERS FOR LARGE SCALE INDOOR AIR SURVEYS?

A new method to evaluate the performance of adsorbents for indoor VOCs purification

A Passive Sampler With Improved Performance For Collecting Gaseous And Particulate Phase Polycyclic Aromatic Hydrocarbons In Air

Calibration of a Passive Sampler for Both Gaseous and Particulate Phase Polycyclic Aromatic Hydrocarbons

A wide range of toxic VOCs measured by dual-sorbent passive sampling with validation by field online measurements

Determination of uptake rates of volatile organic compounds by 24-hour passive sampling and their application in enclosed ship cabin environments

Steady-state model for predicting size-resolved gas-particle partitioning of semi-volatile organic compounds (SVOCs) in indoor environments

Rapid method to measure the concentrations of indoor pollutants by virtue of SPME

A New Look at Diffusion in Vapor Intrusion Assessments; Passive Adsorptive Diffusion Samplers

Numerical prediction model for long- and short-term concentration of indoor volatile organic compounds from building materials

Three-dimensional non-isothermal numerical model for predicting semi-volatile organic compound transport process in a room

A passive air sampler for characterizing the vertical concentration profile of gaseous phase polycyclic aromatic hydrocarbons in near soil surface air.

Uptake behavior of polycyclic aromatic compounds during field calibrations of the XAD-based passive air sampler across seasons and locations

Dynamic Simulation Of Long-term Indoor VOC Concentrations In A Newly Renovated Residential Unit : A Pilot Study

Development and calibration of a modifiable passive sampler for monitoring atmospheric tritiated water vapor in different environments