Abstract:Heavy metals accumulated in slurry of dual alkali flue gas desulfurization (FGD) present a significant catalysis to SO3(2-) oxidation, resulting in a waste of effective components for desulfurization. Na2S was adopted to precipitate heavy metal ions in FGD slurry, and the oxidation rate of SO3(2-) was obtained under different concentrations of heavy metal ions, to reveal the inhibition effect of Na2S on SO3(2-) oxidation catalyzed by heavy metal ions. Mn2+ showed a remarkable catalysis to SO3(-2) oxidation, as the initial oxidation rate of SO3(2-) was tripled to 0.65 mmol/(L x min) by adding 1.0 mmol/L Mn2+ into the slurry. SO3(2-) was catalytically oxidized rapidly with the reaction order 0.169 of Mn2+ within first 60 minutes, so it is of great importance to control the concentration of Mn2+ to inhibit SO3(2-) oxidation. At initial pH value of 6.50-8.50, Na2S removed heavy metal ions effectively from FGD slurry. Higher pH value favored the removal of heavy metal ions. The removal efficiencies of Mn2+, Zn2+, Ni2+ and Cd2+ were 91.0%, 88.1%, 85.5%, and above 99.9% respectively under the conditions of initial pH value 8.50 and Na2S dosage 240.0 mg/L. Mn2+ could be used as an indicator for the concentration of the heavy metal ions in the slurry. As the Mn2+ concentration decreased from 1.0 mmol/L to 5.0 x 10(-3) mmol/L by adding Na2S, the initial oxidation rate of SO3(2-) decreased by 64.6% to 0.23 mmol/(L x min). The desulfurization efficiencies increase 3.8%-5.1% by adding Na2S in a pilot scale setup. It comes to conclusion that heavy metal ions precipitation by adding Na2S with an indicator of Mn2+ to inhibit catalytic oxidation of SO3(2-) is feasible to reduce the consumption of desulfurizer in FGD slurry.

Removal of manganous dithionate (MnS<sub>2</sub>O<sub>6</sub>) with MnO<sub>2</sub> from the desulfurization manganese slurry

Removal of Manganous Dithionate (mns2o6) with MnO2 from the Desulfurization Manganese Slurry

Mechanistic Study on the Enhanced SO2-tolerant Ability of CuCl2-promoted MnOx-CeOx Mixed Oxide for Hg0 Removal

The Formation of Manganous Dithionate in the Manganese Oxide Flue Gas Desulfurization

Manganese Removal from Aqueous Solution Using a Thermally Decomposed Leaf

Removal and Resource Utilization of High Concentration Flue Gas Sulfur Dioxide Using Manganese Carbonate Ore

Oxidation kinetics of dithionate compound in the leaching process of manganese dioxide with manganese dithionate

[Inhibition of Sulfite Oxidation Catalyzed by Heavy Metals in Dual Alkali Flue Gas Desulfurization Slurry].

In-process control of manganese dithionate in the manganese ore-based wet flue gas desulfurization coupled with efficient manganese leaching

Activation of Oxygen with Sulfite for Enhanced Removal of Mn(II): the Involvement of SO4•.

Enhanced Recovery of Dithionate from Desulfurization with Pyrolusite System by Manganese Dioxide Anode of Spent Batteries

Sulfur Dioxide Capture by Heterogeneous Oxidation on Hydroxylated Manganese Dioxide.

Decomposition Characteristics of Manganese Dithionate in Absorption Solution of Flue Gas Desulfurization and Denitration with Pyrolusite Slurry

Promotion of manganese extraction and flue gas desulfurization with manganese ore by iron in the anodic solution of electrolytic manganese

Effect of MnSO4 on the Removal of SO2 by Manganese-Modified Activated Coke

A Theoretical and Experimental Study of SO <sub>2</sub> Oxidation on Crystalline MnO <sub>2</sub> Catalysts

Mechanisms of dry flue-gas desulfurization using natural manganese oxide ores

Mechanistic and thermodynamic insights into the SO2 oxidation on MnO2 catalysts: A combined theoretical and experimental study

REMOVAL OF Cr(Ⅲ)FROM TANNERY SLUDGE BY MnO2

Enhanced Sludge Dewaterability by Efficient Oxidation of Α-Mn2o3/peroxymonosulfate: Analysis of the Mechanism and Evaluation of Engineering Application

Manganese Ore-based Wet Flue-Gas Desulfurization: A Review