Three-dimensional Modeling and Theoretical Investigation of Grinding Marks on the Surface in Small Ball-End Diamond Wheel Grinding
Tingzhang Wang,Henan Liu,Chunya Wu,Jian Cheng,Mingjun Chen
DOI: https://doi.org/10.1016/j.ijmecsci.2020.105467
IF: 7.3
2020-01-01
International Journal of Mechanical Sciences
Abstract:In ultra-precision grinding complex optical components with ball-end diamond wheels, radial runout will cause grinding marks on the workpiece surface, which will severely affect the performance of optical components. Therefore, it is necessary to investigate the formation mechanism of these grinding marks. According to the kinematics of the grinding process, a 3D simulation mathematical model is established to systematically analyze the influence of processing parameters and radial runout on the characteristic parameters of the grinding marks. The inclination angle of the grinding marks is inversely proportional to the absolute value of fractional part of speed ratio and proportional to feed speed, thereby affecting the meridional spatial period. The integer part of the speed ratio significantly affects residual height and is the only factor influencing the circumferential spatial period. The residual height is also affected by other factors. With the fractional part and the grinding wheel radius increasing, and the feed speed, grinding depth, radial runout amplitude and workpiece radius decreasing, the residual height decreases. Finally, through grinding verification experiments on a v-shaped component, a residual height of 0.598 mu m and a spatial period of 97 mu m are obtained and compared with the simulation results of 0.554 mu m and 101 mu m, indicating the accuracy and feasibility of the proposed method. This method can provide a theoretical basis for subsequent grinding marks suppression research.