Abstract:Purpose The purpose of this paper is to develop thermal modelling to investigate the thermal response of sample boards (at board level) during the preheating stage of the reflow process and to validate with experimental measurements. Design/methodology/approach A thermal‐coupling method that adopted the Multi‐physics Code Coupling Interface (MpCCI) was utilized. A forced‐convection reflow oven was modelled using computational fluid dynamic software ( FLUENT 6.3.26 ), whereas structural heating at the board level was conducted using finite‐element method software ( ABAQUS 6.9 ). Findings The simulation showed a complex flow pattern having characteristics of a free‐jet region, stagnation‐flow region, wall jet‐region, recirculation region and vortices. A sharp maximum heat‐transfer coefficient was detected in the stagnation region of the jet, resulting in a spatial variation of local heat transfer on a thermal profile board (TPB). This coefficient affected the temperature distribution in the TPB with different specific heat capacitances and thermal conductivity of the structure. The simulation results were in good agreement with the experimental data and analytical model. The cold region and temperature uniformity (ΔT) increased with increasing complexity of the TPB. The cold region can occur in two possible locations in the TPB. Both occurrences can be related to the flow field of the reflow oven. ΔT of the TPB decreased when the conveyor speed (v) was reduced. A suitable conveyor speed (1.0 cm/s) was determined to maintain ΔT below 10°C, which prevented the thermally critical package from overheating. Practical implications The paper provies a methodology for designing a thermal profile for reflow soldering production. Originality/value The findings provide fundamental guidelines to the thermal‐coupling method at the board and package levels, very useful for accurate control of ΔT at the board and package levels, one of the major requirements in achieving a high degree of reliability for electronic assemblies.

Conjugate Heat Transfer from a Model Package in a Compact Casing

Numerical Simulation of Conjugate Heat Transfer from Multiple Electronic Module Packages Cooled by Air

Nature Convection Heatsink Modeling and Optimization Based on Nusselt Number Correlation

Natural Convection to Air from an Array of Vertical Parallel Plates with Discrete and Protruding Heat Sources

Conjugate Heat Transfer From A Small Heat Source Mounted On The Bottom Wall Of An Enclosure

Evaluation of Heat Conduction and Visualization of Heat Flux in a Plate Making Use of Heat Transfer Experiments

Conjugate Heat Transfer Modeling of a Cold Plate Design for Hybrid-Cooled Data Centers

Characterization and Optimization of the Heat Dissipation Capability of a Chip-On-Board Package Using Finite Element Methods

Numerical simulation of a heat sink embedded with a vapor chamber and calculation of effective thermal conductivity of a vapor chamber

The Development of Effective Model for Thermal Conduction Analysis for 2.5D Packaging Using TSV Interposer

Effect of Thermal Boundary Conditions and Thermal Conductivity on Conjugate Heat Transfer Performance in Pin Fin Arrays

Study of inverse natural convection-conduction heat transfer for in-line tube heat exchanger in a hot box with experimental data

Thermal Circuit Modeling and Numerical Verification for Concurrent Fluid Flows through an Iso-Flux Heated Concentric Double Tube

Numerical and experimental study of inverse natural convection heat transfer for heat sink in a cavity with phase change material

A Detailed Thermal Resistance Network Analysis of FCBGA Package

EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER DEPENDENCY ON CONJUGATE AND CONVECTIVE THERMAL BOUNDARY CONDITIONS IN PIN FIN CHANNEL

Three‐dimensional thermal investigations at board level in a reflow oven using thermal‐coupling method

An Experimental Study of Natural Convection from an Array of Vertical Parallel Plates.

Interactive Influence of Conduction–Convection–Radiation on Heat Transfer from a Discretely and Non-Identically Heated Electronic Gadget

Experimental Investigation on Natural Air Cooling of IC Boards

Investigation of Design Models for Printed Circuit Heat Exchangers with Straight Semicircular Channels