Abstract:The design and development of glass ceramic materials provide us the unique opportunity to study the microstructure development with changes in either base glass composition or heat treatment conditions as well as to understand processing-microstructure-property (mechanical/biological) relationship. In the present work, it is demonstrated how various crystal morphology can develop when F(-) content in base glass (K(2)O-B(2)O(3)-Al(2)O(3)-SiO(2)-MgO-F) is varied in the range of 1.08-3.85% and when all are heat treated at varying temperatures of 1000-1120 degrees C. For some selected heat treatment temperature, the heat treatment time is also varied over 4-24 h. It was established that with increase in fluoride content in the glass composition, the crystal volume fraction of the glass-ceramic decreases. Using 1.08% fluoride, more than 80% crystal volume fraction could be achieved in the K(2)O-B(2)O(3)-Al(2)O(3)-SiO(2)-MgO-F system. It was observed that with lower fluoride content glass-ceramic, if heated at 1040 degrees C for 12 h, an oriented microstructure with 'envelop like' crystals can develop. For glass ceramics with higher fluorine content (2.83% or 3.85%), hexagonal-shaped crystals are formed. Importantly, high hardness of around 8 GPa has been measured in glass ceramics with maximum amount of crystals. The three-point flexural strength and elastic modulus of the glass-ceramic (heat treated at 1040 degrees C for 24 h) was 80 MPa and 69 GPa of the sample containing 3.85% fluorine, whereas, similar properties obtained for the sample containing 1.08% F(-) was 94 MPa and 57 GPa, respectively. Further, in vitro dissolution study of the all three glass-ceramic composition in artificial saliva (AS) revealed that leached fluoride ion concentration was 0.44 ppm, when the samples were immersed in AS for 8 weeks. This was much lower than the WHO recommended safety limits of 1.5 ppm. Among all the investigated glass-ceramic samples, the glass ceramic with 3.85% F(-) content in base glass (heat treated at 1040 degrees C for 12 h), exhibits the adherence of Ca-P layer, which consists of spherical particles of 2-3 mum. Other ions, such as Mg(+2) and K(+1) ion concentrations in the solution were found to be 8 and 315 ppm after 8 weeks of leaching, respectively. The leaching of all metal ions is recorded to decrease with time, probably due to time-dependent kinetic modification of sample surface. Summarizing, the present study illustrates that it is possible to obtain a good combination of crystallization, mechanical and in vitro dissolution properties with the careful selection of base glass composition and heat treatment conditions.

Study on Na<sub>2</sub>O-B<sub>2</sub>O<sub>3</sub>-SiO<sub>2</sub>-CaO-P<sub>2</sub>O<sub>5</sub>-F System Glass-Ceramics

Effect of ZrO(2) additions on the crystallization, mechanical and biological properties of MgO-CaO-SiO(2)-P(2)O(5)-CaF(2) bioactive glass-ceramics

Sintering and Properties of CaO-Al<sub>2</sub>O<sub>3</sub>-B<sub>2</sub>O<sub>3</sub>-SiO<sub>2</sub> System Glass Ceramics

Preparation and Characterization of Low Temperature Heat-Treated 45S5 Bioactive Glass-Ceramic Analogues

Sintering Behavior, Microstructure and Mechanical Properties of Various Fluorine-Containing Y-SiAlON Glass-Ceramics

Phase transformation and mechanical properties of new bioactive glass-ceramics derived from CaO-P2O5-Na2O-B2O3-SiO2 glass system

In Vitro Solubility and Bioactivity of Sr and Mg Co-Doped Calcium Phosphate Glass-Ceramics Derived from Different Heat-Treatment Temperatures

Sintering and properties of CaO-Al2O3-B2O3-SiO2 system glass ceramics

Apatite Formation and Bioactivity of Glass-Ceramics in the System of CaO-P2O5-Na2O-B2O3 Derived from Sol-Gel Method

Nucleation, crystallization and biological activity of Na2O-CaO-P2O5-SiO2 bioactive glass

Investigation of the P2O5–Bi2O3–CaO system: Glass forming region, structure, properties

Incorporation of B2o3 in Cao-Sio2-P2o5 Bioactive Glass System for Improving Strength of Low-Temperature Co-Fired Porous Glass Ceramics

Studies on the crystallization dynamics o Ca-P-Si glass-ceramic

Optimization of mechanical and tribological properties of a dental SiO2-Al2O3-K2O-CaO-P2O5 glass-ceramic

In vitro bioactivity evaluation, mechanical properties and microstructural characterization of Na₂O-CaO-B₂O₃-P₂O₅ glasses

Sol-gel-synthesized bioglass-ceramics: physical, mechanical, and biological properties

Changes of the Mechanical Properties during Crystallization of CaO-P2O5-SiO2-MgO-F- Glass Ceramics

Effect of Ca/Si ratio on the microstructures and properties of CaO–B2O3–SiO2 glass-ceramics

Physical Characteristic and In-Vitro Bioactivity Property of Sintered Glasses made via Sol-Gel and Powder Sintering Process

Microstructure, mechanical, and in vitro properties of mica glass-ceramics with varying fluorine content

Dissolution Behavior and Bioactivity Study of Glass Ceramic Scaffolds in the System of CaO–P2O5–Na2O–ZnO Prepared by Sol–gel Technique