Abstract:Ultra-high nickel single-crystal cathode materials have become the most promising for lithium-ion batteries. However, the preparation of ultra-high nickel single-crystal precursors by a continuous coprecipitation method has the disadvantages of large particle size, wide distribution, poor morphology. The extent of the inhomogeneous reactions can be more severe in single-crystal cathodes with larger particle size. Herein, the coprecipitation method with a solid concentrator was adopted, and citrate sodium was used as a complexing agent to improve the physical properties of precursors and electrochemical performance of single-crystal cathode materials. By analyzing the morphology and agglomeration mechanism of the precursor nucleuses under different pH values, it was found that hexagonal nanosheets grew along the 101 direction, and the primary particles showed thicker at pH of 11.4. The hexagonal nanosheets grew along the 001 direction, and the primary particles showed finer at pH of 12.2. The morphology and particle size uniformity of the secondary particles formed by agglomeration at these two pH values showed poor. However, hexagonal nanosheets grew synergistically along the 001 and 101 directions at pH of 11.8, so the primary particles with uniform particle size gradually agglomerated, and then the secondary particles with ultra-small particle size and uniform distribution obtained. Compared to materials prepared by the traditional continuous coprecipitation method, the precursor displays a smaller particle size(D50 = 1.8 µm), higher sphericity, uniformity and denser internal structure. In order to evaluate the performance of Ni0.94Co0.04Mn0.02(OH)2 with ultra-small particle size, the sintering conditions of LiNi0.94Co0.04Mn0.02O2 need to be explored. It was found that the LiNi0.94Co0.04Mn0.02O2 cathode material prepared at 790 °C exhibited higher discharge capacity, cycle and rate performance, compared to materials prepared at 760 °C and 820 °C. We further utilized TEM, EPMA, and XPS to test the internal structure and valence state of LiNi0.94Co0.04Mn0.02O2 cathode material. The results show that the LiNi0.94Co0.04Mn0.02O2 calcined at 790 °C has a good single crystal structure. The LiNi0.94Co0.04Mn0.02O2 cathode materials inherited the structure and particle size of Ni0.94Co0.04Mn0.02(OH)2 precursors, and displayed discharge capacity of 194.7 mAh/g and capacity retention rate of 89.8 % after 100 cycles at 1 C. The microstructure and phase transition of the as-prepared cathode material are well-maintained after long-term cycling, without obvious inter-crystalline micro-crack. The results indicate that its electrochemical performance is better than that of cathode materials with precursors prepared by a continuous coprecipitation method. This work provides new insights for the preparation of small-particle-size precursor and single-crystal cathode materials.

Preparation and Mechanism of Spherical [Ni<sub>1/3</sub>Co<sub>1/3</sub>Mn<sub>1/3</sub>]Ox Precursors for Li [Ni<sub>1/3</sub>Co<sub>1/3</sub>Mn<sub>1/3</sub>]O<sub>2</sub> by an Ultrasonic Atomization Method

Preparation and mechanism of spherical [Ni1/3Co1/3Mn1/3]OX precursors for Li[Ni1/3Co1/3Mn1/3]O2 by an ultrasonic atomization method

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Monitoring the Formation of Nickel-Poor and Nickel-Rich Oxide Cathode Materials for Lithium-Ion Batteries with Synchrotron Radiation

PREPARATION OF NiO NANOPARTICLES ON THE SILICA SURFACE BY ADSORPTION PHASE SYNTHESIS AND ITS REGULATION ON MORPHOLOGY OF NiO PARTICLES

Synthesis the Precursor of LiNi0.5Mn0.5O2 Via an Improved Carbonate Co-Precipitation

Synthesis and Characterization of Spherical LiNi_(0.8)Co_(0.1)Mn_(0.1)O_2 Particles with a High Tap-density

Microstructure and Electrochemical Characterization of Spherical-Like Orthorhombic LiMnO2 Via Co-Precipitation

Ton-scale preparation of single-crystal Ni-rich ternary cathode materials for high-performance lithium ion batteries

Synthesis Optimization of Li1+X[Mn0.45co0.40ni0.15]O-2 with Different Spherical Sizes Via Co-Precipitation

Synthesis of cathode material LiNi_(1/3)Co_(1/3)Mn_(1/3)O_2 and its electrochemical performances

Preparation, Microstructure And Electrochemical Properties Of Spherical-Like Orthorhombic Limno2

Application of precursor with ultra-small particle size and uniform particle distribution for ultra-high nickel single-crystal cathode materials by coprecipitation method

A green and economical route to the precursor for the synthesis of single crystal LiNi0.5Co0.2Mn0.3O2

Preparation of Ternary Precursor Derived from Spent LiNixCoyMn1−x−yO2 Materials

Well-ordered spherical LiNi xCo (1-2x)Mn xO 2 cathode materials synthesized from cobolt concentration-gradient precursors

Preparation of NiO and CoO Nanoparticles Using M2+-oleate (M = Ni, Co) As Precursor

Synthesis of Spherical LiNi 1/3 Co 1/3 Mn 1/3 O 2 Cathode Materials for Li-ion Batteries

Synthesis and Electrochemical Properties of LiNi0.5Mn1.5O4 by Ultrasonic-Assisted Co-Precipitation Method

Effect of precursor particle size and morphology on lithiation of Ni0.6Mn0.2Co0.2(OH)2

Directional and Orderly Arranged Ni 0.9 Mn 0.1 (OH) 2 Enables the Synthesis of Single-Crystal Ni-Rich Co-Free LiNi 0.9 Mn 0.1 O 2 with Enhanced Internal Structural Stability