Abstract:Ultra-high nickel single-crystal cathode materials have become the most promising for lithium-ion batteries. However, the preparation of ultra-high nickel single-crystal precursors by a continuous coprecipitation method has the disadvantages of large particle size, wide distribution, poor morphology. The extent of the inhomogeneous reactions can be more severe in single-crystal cathodes with larger particle size. Herein, the coprecipitation method with a solid concentrator was adopted, and citrate sodium was used as a complexing agent to improve the physical properties of precursors and electrochemical performance of single-crystal cathode materials. By analyzing the morphology and agglomeration mechanism of the precursor nucleuses under different pH values, it was found that hexagonal nanosheets grew along the 101 direction, and the primary particles showed thicker at pH of 11.4. The hexagonal nanosheets grew along the 001 direction, and the primary particles showed finer at pH of 12.2. The morphology and particle size uniformity of the secondary particles formed by agglomeration at these two pH values showed poor. However, hexagonal nanosheets grew synergistically along the 001 and 101 directions at pH of 11.8, so the primary particles with uniform particle size gradually agglomerated, and then the secondary particles with ultra-small particle size and uniform distribution obtained. Compared to materials prepared by the traditional continuous coprecipitation method, the precursor displays a smaller particle size(D50 = 1.8 µm), higher sphericity, uniformity and denser internal structure. In order to evaluate the performance of Ni0.94Co0.04Mn0.02(OH)2 with ultra-small particle size, the sintering conditions of LiNi0.94Co0.04Mn0.02O2 need to be explored. It was found that the LiNi0.94Co0.04Mn0.02O2 cathode material prepared at 790 °C exhibited higher discharge capacity, cycle and rate performance, compared to materials prepared at 760 °C and 820 °C. We further utilized TEM, EPMA, and XPS to test the internal structure and valence state of LiNi0.94Co0.04Mn0.02O2 cathode material. The results show that the LiNi0.94Co0.04Mn0.02O2 calcined at 790 °C has a good single crystal structure. The LiNi0.94Co0.04Mn0.02O2 cathode materials inherited the structure and particle size of Ni0.94Co0.04Mn0.02(OH)2 precursors, and displayed discharge capacity of 194.7 mAh/g and capacity retention rate of 89.8 % after 100 cycles at 1 C. The microstructure and phase transition of the as-prepared cathode material are well-maintained after long-term cycling, without obvious inter-crystalline micro-crack. The results indicate that its electrochemical performance is better than that of cathode materials with precursors prepared by a continuous coprecipitation method. This work provides new insights for the preparation of small-particle-size precursor and single-crystal cathode materials.

Well-ordered spherical LiNi xCo (1-2x)Mn xO 2 cathode materials synthesized from cobolt concentration-gradient precursors

Cathode Materials of Li_xCo_(0.8)Ni_(0.2)O_2 for Lithium-ion Battery

Preparation and Electrochemical Properties of Li[Ni1/3Co1/3Mn1−x/3Zrx/3]O2 Cathode Materials for Li-ion Batteries

Synthesis and Electrochemical Characteristics of Li₁.₂(Ni₀.₂Mn₀.₆)ₓ(Co₀.₄Mn₀.₄)y(Ni₀.₄Mn₀.₄)₁₋ₓ₋yO₂ (0 ≤ X + Y ≤ 1) Cathode Materials for Lithium Ion Batteries

Microstructure and Electrochemical Characterization of Spherical-Like Orthorhombic LiMnO2 Via Co-Precipitation

Synthesis and Evaluation of Microspherical Li1.2Mn0.54Co0.13Ni0.13O2 Through Carbon Dioxides-assisted Co-precipitation Method for Lithium-ion Battery

Tailored Synthesis of Ni0.25mn0.75co3 Spherical Precursors for High Capacity Li-Rich Cathode Materials Via A Urea-Based Precipitation Method

Preparation of layered LiNi1/3Co1/3-xLaxMn1/3O2 as cathode material by oxalate co-precipitation method

Directional and Orderly Arranged Ni 0.9 Mn 0.1 (OH) 2 Enables the Synthesis of Single-Crystal Ni-Rich Co-Free LiNi 0.9 Mn 0.1 O 2 with Enhanced Internal Structural Stability

Synthesis and Electrochemical Properties of Li[Ni X Co Y Mn 1− X − Y ]O 2 ( X, Y = 2/8, 3/8) Cathode Materials for Lithium Ion Batteries

Electrochemical Performance of LiMn_(2-x)Co_xO_4 Cathode Materials Synthesized by a Co-Precipitation Method

Spherical Agglomeration of Octahedral LiNi0.5Co4xMn1.5-3xO4 Cathode Material Prepared by a Continuous Coprecipitation Method for 5 V Lithium-Ion Batteries

Application of precursor with ultra-small particle size and uniform particle distribution for ultra-high nickel single-crystal cathode materials by coprecipitation method

Synthesis of the Layered-Spinel Intergrowth Structure Cathode Materials by Co-Precipitation Method

Preparation and electrochemical properties of spherical LiMn2O4 surface doped with cobalt

High capacity 0.5Li2MnO3·0.5LiNi 0.33Co0.33Mn0.33O2 cathode material via a fast co-precipitation method

Preparation of Layered LiNi_(1/3)Co_(1/3-x)La_xMn_(1/3)O_2 As Cathode Material by Oxalate Co-Precipitation Method

Synthesis of Spherical LiNi 1/3 Co 1/3 Mn 1/3 O 2 Cathode Materials for Li-ion Batteries

Low-temperature strategy to synthesize single-crystal LiNi0.8Co0.1Mn0.1O2 with enhanced cycling performances as cathode material for lithium-ion batteries

The preparation and electrochemical study of LiNi0.6Co0.2Mn0.2O2 cathode material for lithium-ion battery

Surface Atomic Rearrangement with High Cation Ordering for Ultra-Stable Single-Crystal Ni-Rich Co-Less Cathode Materials