Abstract:The accurate and fast prediction of cutting forces in five-axis milling of free-form surfaces remains a challenge due to difficulties in determining the varying cutter-workpiece engagement (CWE) boundaries and the instantaneous uncut chip thickness (IUCT) along the tool path. This paper proposes an approach to predict the cutting forces in five-axis milling process with a general end mill considering the cutter runout effect that is inevitable in the practical machining operations. Based on the analytical model of cutting edge combined with runout parameters, the expression of the rotary surface formed by each cutting edge undergoing general spatial motion is firstly derived. Then by extracting the feasible contact arc along the tool axis, a new arc-surface intersection method is developed to determine the CWE boundaries fast and precisely. Next, the circular tooth trajectory (CTT) model is developed for the calculation of the IUCT with a slight sacrifice of accuracy. In comparison with the true IUCT calculated by the trochoidal tooth trajectory model, the approximation error introduced by the circular assumption is negligible while the computational efficiency improves a lot. Finally, combining with the calibrated cutting coefficients and runout parameters, comprehensive formulation of the cutting force system is set up. Simulations and experimental validations of a five-axis flank milling process show that the novel CTT model possesses obvious advantages in computing efficiency and accuracy over the existing approaches. Rough machining of a turbo impeller is further carried out to test the practicability and effectiveness of the proposed mechanistic model.

A Novel Approach to Estimating Runout Effect in High-Speed Milling.

A Non-Contact Calibration Method for Cutter Runout with Spindle Speed Dependent Effect and Analysis of Its Influence on Milling Process

Modeling of the Instantaneous Milling Force Per Tooth with Tool Run-out Effect in High Speed Ball-End Milling

Accurate Cutting Force Prediction of Helical Milling Operations Considering the Cutter Runout Effect

Tool Run-Out in Micro-Milling: Development of an Analytical Model Based on Cutting Force Signal Analysis

Evaluation Indicators of the Runout Effects on Milling Forces and Regenerative Stability

Micro-milling force modeling with tool wear and runout effect by spatial analytic geometry

A New Procedure for the Prediction of the Cutting Forces in Peripheral Milling

Prediction of milling force based on identified milling force coefficients and tool runout parameters in time-frequency domain

Analysis and modeling of cutting force considering the tool runout effect in longitudinal-torsional ultrasonic vibration-assisted 5 axis ball end milling

Micro-milling tool wear monitoring under variable cutting parameters and runout using fast cutting force coefficient identification method

A general on-machine non-contact calibration method for milling cutter runout

Deep learning-based method for characterizing the cutter runout phenomenon in micro milling

A chatter free calibration method for determining cutter runout and cutting force coefficients in ball-end milling

Generic Instantaneous Force Modeling and Comprehensive Real Engagement Identification in Micro-Milling

Mechanistic Modeling of Five-Axis Machining with a General End Mill Considering Cutter Runout

A generic tool wear model and its application to force modeling and wear monitoring in high speed milling

In-situ Tool Wear Area Evaluation in Micro Milling with Considering the Influence of Cutting Force

An Efficient Approach for Milling Dynamics Modeling and Analysis with Varying Time Delay and Cutter Runout Effect

Identification of Spindle Runout Parameters in Micro-Ball-End Milling

Tool Runout and Single-Edge Cutting in Micro-Milling