Abstract:This article presents a fully integrated digital polar transmitter (DPTX) incorporating an efficiency-enhanced digital power amplifier (DPA) and a high-resolution digital-to-time converter (DTC). The proposed single-ended Doherty (SED) PA topology with switched-capacitor (SC) arrays can generate four power efficiency peaks that significantly improve the power-added efficiency (PAE) at the power amplifier (PA)’s power back-offs (PBOs). In addition, this work utilizes a three-segment DTC, built with a delay-locked loop (DLL), to improve the phase resolution and enable real-time process-voltage-temperature (PVT) calibration of the DTC. Fabricated in a 28 nm CMOS technology, the DPTX achieves a peak output power ( $P_{\mathrm{out}})$ of 27.7 dBm and a peak PAE of 33.4% at a 2.1 GHz carrier frequency. The PAEs at 2.5, 6, and 12 dB PBOs are 31.1%, 24.5%, and 18%, respectively. With the 2.1 GHz carrier, the DTC achieves 360 $^{\circ}$ full output phase range, $\pm$ 1.3 $^{\circ}$ differential nonlinearity (DNL), $\pm$ 1.7 $^{\circ}$ integral nonlinearity (INL), and $-$ 133.86 dBc/Hz phase noise at a frequency offset of 1 MHz, while the power dissipation is only 14 mW. When testing the 10 MHz (and 20 MHz) long term evolution (LTE) 64 QAM signals with a 6.2 (5.0) dB peak-to-average power ratio (PAPR), the DPTX achieves an average $P_{\mathrm{out}}$ of 21.5 (22.7) dBm, an average PAE of 23.5% (24.6%), an average system efficiency (SE) of 22.5% (23.8%)–, 30.6 (–27.7) dB error vector magnitude (EVM), and –34.2/–32.6 (–30.1/–29.2) dBc adjacent channel leakage ratio (ACLR). Note that these results have been achieved with only the on-chip digital pre-distortion (DPD) algorithm.

Design of CMOS Digital Power Amplifier Applied in Digital Polarized Transmitter

The Design of All-Digital Polar Transmitter Based on ADPLL and Phase Synchronized ΔΣ Modulator

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

Wideband Digital Power Amplifiers With Efficiency Improvement Using 40-nm LP CMOS Technology

A CMOS 135–150 GHz 0.4 dBm EIRP transmitter with 5.1dB P1dB extension using IF envelope feed-forward gain compensation

A 3.5–9.5 GHz compact digital power amplifier with 39.3% peak PAE in 40nm CMOS technology

1.2–2.8-Ghz 32.4-Dbm Digital Power Amplifier with Balance-Compensated Matching Network

Digitally Equalized CMOS Transmitter Front-End with Integrated Power Amplifier

A CMOS Wideband Watt-Level 4096-QAM Digital Power Amplifier Using Reconfigurable Power-Combining Transformer

A Fully Integrated Digital Polar Transmitter with Single-Ended Doherty PA and DLL-Based Three-Segment Hybrid DTC in 28 Nm CMOS

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A Compact 2.4ghz Polar/quadrature Reconfigurable Digital Power Amplifier in 28nm Logic LP CMOS

A Ka-Band CMOS Power Amplifier With OP1dB Improvement Employing a Diode-Connected Analog Linearizer

A Compact Dual-Band Digital Polar Doherty Power Amplifier Using Parallel-Combining Transformer.

A Compact Transformer-Combined Polar/Quadrature Reconfigurable Digital Power Amplifier in 28-Nm Logic LP CMOS

24.5 A 15b Quadrature Digital Power Amplifier with Transformer-Based Complex-Domain Power-Efficiency Enhancement.

Development of Millimeter-Wave Power Amplifier Using CMOS Process

A 4.1 W Quadrature Doherty Digital Power Amplifier with 33.6% Peak PAE in 28nm Bulk CMOS.

A Fully-Integrated Wideband Digital Polar Transmitter with 11-Bit Digital-to-Phase Converter in 40nm CMOS.

Design and Implementation of 75 W RF Power Amplifier for Digital TV Transmitter

A Highly Linear Fully Integrated CMOS Power Amplifier with an Analog Predistortion Technique