Abstract:This article presents a fully integrated digital polar transmitter (DPTX) incorporating an efficiency-enhanced digital power amplifier (DPA) and a high-resolution digital-to-time converter (DTC). The proposed single-ended Doherty (SED) PA topology with switched-capacitor (SC) arrays can generate four power efficiency peaks that significantly improve the power-added efficiency (PAE) at the power amplifier (PA)’s power back-offs (PBOs). In addition, this work utilizes a three-segment DTC, built with a delay-locked loop (DLL), to improve the phase resolution and enable real-time process-voltage-temperature (PVT) calibration of the DTC. Fabricated in a 28 nm CMOS technology, the DPTX achieves a peak output power ( $P_{\mathrm{out}})$ of 27.7 dBm and a peak PAE of 33.4% at a 2.1 GHz carrier frequency. The PAEs at 2.5, 6, and 12 dB PBOs are 31.1%, 24.5%, and 18%, respectively. With the 2.1 GHz carrier, the DTC achieves 360 $^{\circ}$ full output phase range, $\pm$ 1.3 $^{\circ}$ differential nonlinearity (DNL), $\pm$ 1.7 $^{\circ}$ integral nonlinearity (INL), and $-$ 133.86 dBc/Hz phase noise at a frequency offset of 1 MHz, while the power dissipation is only 14 mW. When testing the 10 MHz (and 20 MHz) long term evolution (LTE) 64 QAM signals with a 6.2 (5.0) dB peak-to-average power ratio (PAPR), the DPTX achieves an average $P_{\mathrm{out}}$ of 21.5 (22.7) dBm, an average PAE of 23.5% (24.6%), an average system efficiency (SE) of 22.5% (23.8%)–, 30.6 (–27.7) dB error vector magnitude (EVM), and –34.2/–32.6 (–30.1/–29.2) dBc adjacent channel leakage ratio (ACLR). Note that these results have been achieved with only the on-chip digital pre-distortion (DPD) algorithm.

A Compact 2.4ghz Polar/quadrature Reconfigurable Digital Power Amplifier in 28nm Logic LP CMOS

A Compact Transformer-Combined Polar/Quadrature Reconfigurable Digital Power Amplifier in 28-Nm Logic LP CMOS

A Ka-band 8-Element 4-Beam Transmitter Front End with Hybrid VGA and Symmetrical Transformer-based Doherty PA

A Compact Dual-Band Digital Polar Doherty Power Amplifier Using Parallel-Combining Transformer.

A 4.1 W Quadrature Doherty Digital Power Amplifier with 33.6% Peak PAE in 28nm Bulk CMOS.

A Transformer-Based Quadrature Doherty Digital Power Amplifier With 4.1 W Peak Power in 28 nm Bulk CMOS

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A Transformer-Combined 31.5 Dbm Outphasing Power Amplifier in 45 Nm LP CMOS with Dynamic Power Control for Back-Off Power Efficiency Enhancement

A 60-Ghz CMOS Balanced Power Amplifier with Miniaturized Quadrature Hybrids Achieving 19.0-Dbm Output Power and 24.4% Peak PAE

24.5 A 15b Quadrature Digital Power Amplifier with Transformer-Based Complex-Domain Power-Efficiency Enhancement.

A 5-Ghz Quadrature Switched-Capacitor Power Amplifier with IQ-Cell-Sharing and Serial Transformer Combiner in 28-Nm CMOS

A 32.3dbm Quadrature Complex Domain Doherty Power Amplifier Based on Switched Constant-Current and Symmetrical Transformer Achieving 21.6% Average Power-Added Efficiency

A 31.5dbm Outphasing Class-D Power Amplifier in 45nm CMOS with Back-off Efficiency Enhancement by Dynamic Power Control.

A Compact 140-Ghz CMOS Power Amplifier with 10.5-Dbm Output Power and 27.6-Db Power Gain Supporting Up to 128-QAM Modulation

A Quadrature Digital Power Amplifier With Wide Efficiency Enhancement Coverage and High Dynamic Power Range

A Compact Mixed-Mode 62 GHz Doherty Power Amplifier with 28.9% Peak PAE and 14.2 Dbm OP1dB Using Dynamic Power Allocation

A Flip-Chip-Packaged 25.3 dBm Class-D Outphasing Power Amplifier in 32 nm CMOS for WLAN Application

A 15-Bit Quadrature Digital Power Amplifier With Transformer-Based Complex-Domain Efficiency Enhancement

A Fully Integrated Digital Polar Transmitter with Single-Ended Doherty PA and DLL-Based Three-Segment Hybrid DTC in 28 Nm CMOS

A Compact 19.7-to 43.8-Ghz Power Amplifier with 20.3-Dbm $p_{\mathrm{sat}}$ and 35.5% PAE in 28-Nm Bulk CMOS

A 26.4-Db Gain 15.82-Dbm 77-Ghz CMOS Power Amplifier with 15.9% PAE Using Transformer-Based Quadrature Coupler Network