Abstract:This article presents a fully integrated digital polar transmitter (DPTX) incorporating an efficiency-enhanced digital power amplifier (DPA) and a high-resolution digital-to-time converter (DTC). The proposed single-ended Doherty (SED) PA topology with switched-capacitor (SC) arrays can generate four power efficiency peaks that significantly improve the power-added efficiency (PAE) at the power amplifier (PA)’s power back-offs (PBOs). In addition, this work utilizes a three-segment DTC, built with a delay-locked loop (DLL), to improve the phase resolution and enable real-time process-voltage-temperature (PVT) calibration of the DTC. Fabricated in a 28 nm CMOS technology, the DPTX achieves a peak output power ( $P_{\mathrm{out}})$ of 27.7 dBm and a peak PAE of 33.4% at a 2.1 GHz carrier frequency. The PAEs at 2.5, 6, and 12 dB PBOs are 31.1%, 24.5%, and 18%, respectively. With the 2.1 GHz carrier, the DTC achieves 360 $^{\circ}$ full output phase range, $\pm$ 1.3 $^{\circ}$ differential nonlinearity (DNL), $\pm$ 1.7 $^{\circ}$ integral nonlinearity (INL), and $-$ 133.86 dBc/Hz phase noise at a frequency offset of 1 MHz, while the power dissipation is only 14 mW. When testing the 10 MHz (and 20 MHz) long term evolution (LTE) 64 QAM signals with a 6.2 (5.0) dB peak-to-average power ratio (PAPR), the DPTX achieves an average $P_{\mathrm{out}}$ of 21.5 (22.7) dBm, an average PAE of 23.5% (24.6%), an average system efficiency (SE) of 22.5% (23.8%)–, 30.6 (–27.7) dB error vector magnitude (EVM), and –34.2/–32.6 (–30.1/–29.2) dBc adjacent channel leakage ratio (ACLR). Note that these results have been achieved with only the on-chip digital pre-distortion (DPD) algorithm.

1.2–2.8-Ghz 32.4-Dbm Digital Power Amplifier with Balance-Compensated Matching Network

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

28.8 A 21dBm-OP<inf>1dB</inf> 20.3%-Efficiency -131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

A 21dBm-OP1dB 20.3%-Efficiency-131.8dBm/Hz-Noise X-Band Cartesian-Error-Feedback Transmitter with Fully Integrated Power Amplifier in 65nm CMOS

High-Efficiency Digital Power Amplifier Design Based on 22-nm CMOS Process

A CMOS Wideband Watt-Level 4096-QAM Digital Power Amplifier Using Reconfigurable Power-Combining Transformer

1.2–3.6 GHz 32.67 Dbm 4096-QAM Digital PA Using Reconfigurable Power Combining Transformer for Wireless Communication

A 3.5–9.5 GHz compact digital power amplifier with 39.3% peak PAE in 40nm CMOS technology

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A 39 GHz Doherty-Like Power Amplifier With 22dBm Output Power and 21% Power-Added Efficiency at 6dB Power Back-Off

A Compact 140-Ghz CMOS Power Amplifier with 10.5-Dbm Output Power and 27.6-Db Power Gain Supporting Up to 128-QAM Modulation

Digitally Equalized CMOS Transmitter Front-End with Integrated Power Amplifier

A Ka-Band CMOS Power Amplifier With OP1dB Improvement Employing a Diode-Connected Analog Linearizer

24.5 A 15b Quadrature Digital Power Amplifier with Transformer-Based Complex-Domain Power-Efficiency Enhancement.

A Quadrature Digital Power Amplifier With Wide Efficiency Enhancement Coverage and High Dynamic Power Range

A Compact 2.4ghz Polar/quadrature Reconfigurable Digital Power Amplifier in 28nm Logic LP CMOS

A Compact Mixed-Mode 62 GHz Doherty Power Amplifier with 28.9% Peak PAE and 14.2 Dbm OP1dB Using Dynamic Power Allocation

A Fully Integrated Digital Polar Transmitter with Single-Ended Doherty PA and DLL-Based Three-Segment Hybrid DTC in 28 Nm CMOS

A 60ghz Digitally-Assisted Power Amplifier With 17.2dbm P-Sat, 11.3% Pae In 65nm Cmos

A 4.1 W Quadrature Doherty Digital Power Amplifier with 33.6% Peak PAE in 28nm Bulk CMOS.

A Fully-Integrated Wideband Digital Polar Transmitter with 11-Bit Digital-to-Phase Converter in 40nm CMOS.