Abstract:Introduction As major constituents of the Earth’s core, iron (Fe) and its alloys have long been of great interest to geophysicists [1]. Information on their high-pressure behavior, such as phase relations and equations of state (EOSs), is essential for interpreting seismic and geomagnetic observations and for numerical modeling of the Earth’s deep interior. Seismic observations coupled with laboratory research indicate that the density of the outer core and perhaps the inner core is lower than that of pure Fe, which has led to extensive research on possible lower-atomicweight components in the Earth’s core. Silicon (Si) has been suggested as a possible candidate for one of the light elements on the basis of geochemical evidence [2], and previous work has shown than the addition of a modest amount of Si (i.e., as little as 2-4 wt%) to Fe can have a profound effect on the Fe [3]. The EOSs of a number of Fe-Si alloys have been investigated recently [4]. However, the hydrostatic behavior of Fe-rich Fe-Si alloys had not been previously investigated. For the ε-phase, the axial (c/a) ratio is measure of configurational changes and is a good indicator of anisotropy. Accurate determination of the c/a ratio as a function of pressure is critical for investigating the possible origin of core anisotropy [5]. Hydrostatic measurements provide a better constraint on c/a for two reasons. Individual lines are sharper because of the reduced lattice strain, which results in a smaller d-spacing error. The effects of preferred orientation are also reduced, so the 00l lines, which are normally lost in the presence of uniaxial stress, are retained. This allows for the direct determination of c. In this article, we report on the results of a study on the compression (to 50 GPa) of Fe with 7.9 wt% Si at room temperature.

Effect of Hydrogen on the Melting Temperature of Fe–FeS System at High Pressure

The Melting Curves and Entropy of Iron under High Pressure

High-Pressure Iron-Sulfur Compound, Fe3S2, and Melting Relations in the Fe-FeS System

Effect of Ni on Fe–FeS Phase Relations at High Pressure and High Temperature

High Pressure Chemistry in the H 2 -Sih 4 System

Elastic Properties Of Single Crystal Hydrogen Sulfide: A Brillouin Scattering Study Under High Pressure-Temperature

Hydrogen sulfide at high pressure: change in stoichiometry

Electronic, phononic, and superconducting properties of FeHx (x=1-6) at 150 GPa

High-Pressure Iron-Sulfur Compound, Fe <sub>3</sub> S <sub>2</sub> , and Melting Relations in the Fe-FeS System

High-Pressure Behavior of Iron Sulfide

High-temperature Superconductivity in Sulfur Hydride Evidenced by Alternating-Current Magnetic Susceptibility

Melting Experiments on Fe‐O‐H and Fe‐H: Evidence for Eutectic Melting in Fe‐FeH and Implications for Hydrogen in the Core

Influence of Fe Content on the Microstructure and Hydrogen Storage Properties of Ti16Zr5Cr22V57−xFex (x = 2–8) Alloys

The metallization and superconductivity of dense hydrogen sulfide

High-pressure structural phase transitions and metallization in layered HfS2 under different hydrostatic environments up to 42.1 GPa

High-pressure Raman Study of Solid Hydrogen Up to 300 GPa

Nuclear Resonant X-Ray Scattering of Iron Hydride at High Pressure

Structures of FeS Polymorphs at High Pressure and Temperature.

High-Pressure Chemistry of Hydrogen in Metals: in Situ Study of Iron Hydride

Hydrostatic Compression of Fe-Si Alloy

Suppression of superconductivity and structural phase transitions under pressure in tetragonal FeS