Abstract:Medium-voltage (MV) power converts have various intended applications in renewable energy resources integration, power substations, and electrical mobility. The high power and high switching frequency of MV power converters have necessitated the development of a contactless current sensing technique based on magnetoresistive (MR) sensors to provide galvanic isolation, wide bandwidth, and minimum stray inductive on the current path. The prevailing solution involves placing the MR sensor under a straight printed circuit board (PCB) trace. However, this setup suffers reduced sensitivity due to sensor installation errors and inaccurate measurement owing to the nearby interfering conductors. To address these two issues, a double circular PCB trace is proposed to replace the traditional straight PCB trace. In the proposal, two MR sensors are encircled by a circular PCB trace separately. The interference impact is mitigated by subtracting the differential output from the sensors. Additionally, the double circular trace (DC trace) is optimally designed to enhance the position tolerance of sensor installation by providing a uniform magnetic field within the sensing area. The experiment measurement under a 2 mm position error shows that the proposed method improves the sensitivity from 0.1736 V/A in the conventional straight trace to 0.5902 V/A. Moreover, the sensitivity remains consistent even in the presence of interfering conductors.

A Symbolic Sensitivity Method for Mismatch Analysis and CMRR Improvement

MMIC on-Wafer Test Method Based on Hybrid Balanced and Unbalanced RF Pad Structures

Test Signal Design and Analysis for Multi-Channel Identification

A Complementary Fully Differential Dynamic Comparator with Insensitive Common-Mode Mismatch

Matching Technique of CMOS Analog IC Design and Its Application

An Improved Gain Perturbation Method for Common-Mode Rejection Ratio Analysis

A Capacitor Paring Technique for Capacitor Mismatch Reduction

A Low Mismatch Error and High Dynamic Range CMOS Smart Temperature Sensor Based on Operational Modes Switching

Model plant mismatch detection algorithm based on subspace approach

Sensitivity and Uncertainty Analysis of Nonideal Calibration Standards for 16-Term Error Model

Common-Mode Noise Reduction in Noncontact Biopotential Acquisition Circuit Based on Imbalance Cancellation of Electrode-Body Impedance

Measuring and Calibrating of the Parasitic Mismatch in MEMS Accelerometer Based on Harmonic Distortion Self-Test

A Novel Front-End Design for Bioelectrical Signal Wearable Acquisition

A Low-Offset Calibration-Free Comparator with a Mismatch-Suppressed Dynamic Preamplifier

Miniature Active Differential Magnetic Field Probe with High Sensitivity for Near-Field Measurements

Comparator Common-Mode Variation Effects Analysis And Its Application In Sar Adcs

Snr Mismatch and Robust Schemes in Map-Based Iterative Detection System with Cpm

Design and Verification of Ultra Low Current Mode Amplifier Aiming at Biosensor Applications

Design of Low-Offset Low-Power CMOS Amplifier for Biosensor Application

A Size Sensitivity Method for Interactive CMOS Circuit Sizing

Anti-Interference Current Sensing With Enhanced Sensitivity Based on Magnetoresistive Sensors