Abstract:The high voltage bushing on the grid side of UHV converter transformer is located at the connection position between the grid side winding of converter transformer and the AC side system, which is the key equipment of UHVDC transmission system. In actual operation, the bushing will bear high temperature, large load current and additional load for a long time. In addition, due to the limitation of process level. During the rolling process of bushing capacitor core, there are inevitably some defects such as plate wrinkle, plate offset and unreliable grounding of the end plate. Under the long-term action of electricity, heat and stress, small defects are likely to develop into larger defects or even cause faults. Therefore, it is of great significance to study the influence of different defects on the electric field distribution in the bushing core and the partial discharge initial voltage (PDIV) of the bushing. On the basis of 550kV capacitive bushing, this paper designed and manufactured four scaled models. The rated working voltage of scaled models are 31.8kV. And the corresponding finite element simulation models are also established. The simulation results show that the wrinkle defect and offset defect will cause serious electric field distortion, resulting in a sharp increase of electric field at the defect. Ungrounded defects will completely change the distribution of electric field in the bushing, making the electric field concentrated in the insulating oil between the flange and the end plate. The measurement of PDIV shows that the wrinkle defect and offset defect can significantly reduce the PDIV which makes the bushing prone to PD at a lower voltage level and lead to fault. The initial voltage drop of ungrounded partial discharge is less, but the discharge amount is large. Therefore, the research of this paper has guiding significance for timely finding the original defects of bushing, preventing the development of defects, and solving the problem of frequent failure of converter bushing.

Study on the Formation of Capacitor Screen Deformation of Dry-type DC Bushing Core and Its Effect on Electric Field Distribution

Influence Analysis on Defects in Bushing Core at Grid Side of Converter Transformer

Influence of Defects on the Electric Field Distribution of ±800kV Butt-type DC Wall Bushing

An Investigation on the Evolution of Insulation Performance of BOPP Films for Power Capacitors under Multi Physical Fields Aging

Investigation on distribution of electro-thermal coupled field and improved design of 1100 kV converter valve-side bushing

A Study on Temperature Distribution Within HVDC Bushing Influenced by Accelerator Content During the Curing Process

Simulation analysis and calculation of electric field distribution characteristics of UHV wall bushing

Investigation on distribution of electro-thermal coupling fields influenced by HVDC bushing insulation properties

Degradation Behavior and Mechanism of Metalized Film Capacitor under Ultrahigh Field

Simulation on Electrical Field Distribution of Polluted HVDC Wall Bushing

Electrothermal Coupling Filed Calculation of 200 kV Adaptive Bushing

Research on the Overheating Fault of HVDC Wall Bushing and Its Dignosis Strategies Based on CFD

Effects of Typical Defects on Electrical Fields in High-Voltage (Storage) Capacitors

Failure mechanism of metallized film capacitors under DC field superimposed AC harmonic: From equipment to material

Research on the dynamic characteristics of electric field distribution of the ± 1100 kV Ultra high voltage converter transformer valve‐side bushing using weakly ionised gas conductance model

Study on Transients and Effect on Capacitor Voltage Transformer Caused by Disconnector Switching of UHV Series Capacitor Banks

Surface Charge Accumulation Characteristics of Converter Transformer Valve-side Bushing and Influence on DC Transient Electric Field

Degradation Characteristics of Insulation Near Aluminium Foil Edges Inside Dry‐type Bushing Cores under Electrothermal Compound Stress

Application of Electrothermal Coupling Field Analysis to Electric Field Distribution Calculation of ±800 kV Wall Bushing

Electro-thermal Coupling Model for Computation of Radial Temperature and Electric Field of Resin Impregnated Paper High Voltage Direct Current Bushing

A Conversion Method for Plate Distribution of AC Capacitor Bushing Core