Electro-thermal Coupling Model for Computation of Radial Temperature and Electric Field of Resin Impregnated Paper High Voltage Direct Current Bushing

ZHANG Shiling,PENG Zongren,LIU Peng,HU Wei,WANG Haoran

DOI: https://doi.org/10.13334/j.0258-8013.pcsee.2013.22.026

2013-01-01

Abstract:Distribution of radial electric and temperature field is an important parameter to characterize performance of resin impregnated paper (RIP) high voltage direct current (HVDC) bushings. Moreover, it has a direct connection with long-term operation performance of bushing condenser. Ohmic heating of inner conductor and joule heating of insulation medium can establish temperature gradient inside bushing condenser. In addition, conductivity of insulation media is closely related with temperature and E-field distribution depends on conductivity under static DC application, so computation of electric and temperature field in HVDC bushing is a mutual coupling process. In the paper, cylinder model of bushing condenser was established, and derivation of semi-analytical theory formula was also conducted to achieve decoupling calculation of electric and temperature field. Based on this, finite element electro-thermal coupling model and calculation process were proposed, and the results under these two models in actual bushing structure have been compared. The results are in good agreement which proving validity of finite element electro-thermal coupling model. Then finite element model was used in cone model which is much closer to actual condenser structure. Moreover, optimization design for condenser outer contour structure was also conducted to make sure that the hottest-spot temperature is close to 90℃ under rated operating condition, and maximum radial E-field strength is approximately equal to 3.5 kV/mm and distributed uniformly. Finally, temperature rise and electrical performance test were carried out on a RIP HVDC bushing prototype, which can verify the feasibility of optimized design. The electro-thermal coupling theory and FEM model proposed in this paper, as well as electro-thermal decoupling calculation method and condenser optimization design process have good theoretical guiding significance for development of higher voltage RIP DC bushings.