Abstract:Exit burrs are easily generated on workpiece edges. In grinding process, particularly, exit burrs could deteriorate the highly required precision and even affect the functionality of components. Therefore, to understand the burr formation mechanism and control it in grinding process is of great significance. To this end, this paper investigates the features and mechanism of exit burr formation, as well as the influence of grinding conditions including grinding speed, grinding depth, wheel granularity, and grinding pass sequences on the exit burr formation of 12CrMoV stainless steel using the Al 2 O 3 grinding wheels. A 3D finite element (FE) model of single-grit scratching process was developed for explaining the exit burr formation procedures. The effects of different grinding conditions on the exit burr sizes were analyzed, and the characteristics of the exit burr sizes and hardness were observed via experiments. It was found that the whole procedure of exit burr formation during grinding could be divided into six stages: steady-state grinding, pre-initiation, appearance of the fourth deformation zone, formation of plastic deformation band, burr development, and finish of burr formation. The burr sizes were strongly determined by the wheel granularity and grinding depth, rather than the grinding speed. For the same required grinding depths, using whether single pass or multiple passes of the grit has a very small impact on the exit burr sizes. The hardness of the burr root part is relatively stronger than that of the burr rollover part, while the burr hardness would increase when decreasing the grinding depth.

A study on exit burr formation in grinding process-Simulation and experiment

Numerical and experimental investigation on grinding-induced exit burr formation

Numerical Investigation of the Evolution of Grit Fracture and Its Impact on Cutting Performance in Single Grit Grinding

Prediction and Verification Analysis of Grinding Force in the Single Grain Grinding Process of Fused Silica Glass

Theoretical Generalization and Research on the Mechanism of the Unsteady-State Grinding Technique

Experimental Research on the Effect of Grinding Parameters on Ceramic Machined Surface Roughness

Study on Burr Formation in Face Milling of Stainless Steel with Chamfered Cutting Tool

Three-dimensional Modeling and Theoretical Investigation of Grinding Marks on the Surface in Small Ball-End Diamond Wheel Grinding

Finite Element Analysis of Burr Formation and an Automatic Online Micro-Deburring Method in Precise End-Face Grinding Process

Mechanism of Burr Formation and Control Methods in Slot Milling Al-alloy

Subsurface deformation and burr formation in nickel-based single-crystal superalloy under grinding

Mechanism Of Burr Formation In Slot Milling Al-Alloy

Interference and grinding characteristics in ultra-precision grinding of thin-walled complex structural component using a ball-end grinding wheel

Study on the removal mechanism in multi-abrasive micro-grinding of nickel-based superalloy

Investigation of Modeling on Single Grit Grinding for Martensitic Stainless Steel

The study on the influences of superabrasive grain spatial orientation for microcutting processes based on response surface methodology

Simulation and experiment study of burrs in micro-milling Zr-based metallic glass

Modeling and Simulation of Single Abrasive-Grain Cutting Process in Creep Feed Grinding

Research on Microscopic Grain-Workpiece Interaction in Grinding through Micro-Cutting Simulation, Part 2: Factorial Study

Study on the removal mechanism of Si3N4 ceramic material in rotary ultrasonic grinding based on multi-abrasive coupling simulation

The Modelling and Experimental Verification of the Grinding Wheel Topographical Properties Based on the 'Through-the-process' Method