Abstract:This paper presents advancements in the performance of digital phase-locked loop (DPLL)s, with a special focus on addressing the issue of required gain calibration in the time-to-digital converter (TDC) within phase-domain DPLL structures. Phase-domain DPLLs are preferred for their simplicity in implementation and for eliminating the delta–sigma modulator (DSM) noise inherent in conventional fractional-N designs. However, this advantage is countered by the critical need to calibrate the gain of the TDC. The previously proposed dual-interpolated TDC(DI-TDC) was proposed as a solution to this problem, but strong spurs were still generated due to the TDC resolution, which easily became non-uniform due to PVT variation, degrading performance. To overcome these problems, this work proposes a DPLL with a new calibration system that ensures consistent TDC resolution matching the period of the digitally controlled oscillator (DCO) and operating in both the foreground and background, thereby maintaining consistent performance despite PVT variations. This study proposes a DPLL using a calibrated dual-interpolated TDC that effectively compensates for PVT variations and improves the stability and performance of the DPLL. The PLL was fabricated in a 28-nm CMOS process with an active area of only 0.019 mm2, achieving an integrated phase noise (IPN) performance of −17.5 dBc, integrated from 10 kHz to 10 MHz at a PLL output of 570 MHz and −20.5 dBc at 1.1 GHz. This PLL operates within an output frequency range of 475 MHz to 1.1 GHz. Under typical operating conditions, it consumes only 930 μW with a 1.0 V supply.

A Nonlinearity-Calibration-Free Reconfigurable ADPLL for General Purpose Frequency Modulation.

A Fractional-N PLL for Multiband (0.8–6 GHz) Communications Using Binary-Weighted D/A Differentiator and Offset-Frequency Δ-Σ Modulator

A Compact 0.8–6ghz Fractional-N PLL with Binary-Weighted D/A Differentiator and Offset-Frequency Δ−Σ Modulator for Noise and Spurs Cancellation

A 12-Ghz Calibration-Free All-Digital PLL for FMCW Signal Generation with 78 MHz/μs Chirp Slope and High Chirp Linearity.

A 1mb/s 2.86% EVM GFSK Modulator Based on ΔΣ BB-DPLL Without Background Digital Calibration

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS

A Calibration-Free Fractional-N ADPLL Using Retiming Architecture and a 9-Bit 0.3Ps-Inl Phase Interpolator.

A Calibration-Free 800 MHz Fractional-N Digital PLL With Embedded TDC

A Hybrid Loop Two-Point Modulator Without DCO Nonlinearity Calibration by Utilizing 1 Bit High-Pass Modulation

A Digital-Intensive F/Pll-Based Two-Point Modulator with A Constant-Gain Dco for Linear Fmcw Generation

A 3.2-to-4.6 GHz Fast-Settling All-Digital PLL with Feed Forward Frequency Presetting.

A 7.8 Mw 5.2% FSK Error Two-Point Modulator Without Calibration.

A High-Resolution, High-Linearity, Two-Step Time-to-Digital Converter for Wideband Counter-Assisted ADPLL in 0.13um CMOS

A 5.4 GHZ All-Digital Phase-Locked Loop with a wide output swing and high-linearity DAC

A Low-Power Calibration-Free Fractional-N Digital Pll with High Linear Phase Interpolator

A Ku-Band FSK Modulated Fractional-N PLL With Fine Frequency Resolution

A 11.1-to-14.2 GHz Self-adapted Two-point Modulation Dual-path Type-II Digital PLL Concurrently Achieving 124.7-Mhz/μs Chirp Rate and 2.27-Ghz Bandwidth

A Fully Synthesizable Fractional-N Digital Phase-Locked Loop with a Calibrated Dual-Referenced Interpolating Time-to-Digital Converter to Compensate for Process–Voltage–Temperature Variations

A 2.4 GHz Two-Point Δ-Σ Modulator with Gain Calibration and AFC for WPAN/BAN Applications.

A 1.6&#x2013;880mhz Synthesizable ADPLL in 0.13um CMOS

A 1.2ps-jitter fully-synthesizable fully-calibrated fractional-N injection-locked PLL using true arbitrary nonlinearity calibration technique