High-precision, mass dependent Si isotope measurements via the critical mixture double-spiking technique
Xiaoning Liu,Martijn Klaver,Remco C Hin,Christopher David Coath,Hong Chin Ng,Tim Elliott
DOI: https://doi.org/10.1039/d4ja00152d
2024-09-02
Journal of Analytical Atomic Spectrometry
Abstract:We have developed a new method for measuring mass dependent Si isotope fractionation via critical mixture double-spiking. Samples are required to be spiked before column chemistry to guarantee full equilibrium between sample and double-spike (29Si-30Si spike). An iterative addition of the double-spike to the sample, usually 2-4 times, is needed to generate a solution very close to the critically spiked mixture. We use a double-pass cyclonic quartz spray chamber, as it gives the highest signal-to-noise. In conjunction with 6 μg/ml Si solution to yield intense Si isotope beams, this setup results in ~25 V (with 1011 resistor) signal on 28Si+, while on-peak noise is less than 0.06 V. In a typical sample analysis of eight repeat measurements, the 2s.e. of the mean is approximately ±0.030‰ (δ30/28Si), consuming about 13 μg Si in total. Over a 16 month period the reproducibility of this mean value is ±0.030‰ (2s.d., δ30/28Si), which is 2 to 8 times better than the long-term reproducibility of traditional Si isotope measurement methods (~ ±0.1‰,2s.d., δ30/28Si). This agreement between the short term and long-term statistics illustrate that the data sample the same population over the short and long terms, i.e., there is no scatter on timescale of 16 months additional to that we observe over twenty hours (the typical timescale in one analytical session). Thus, for any set of n repeats, including n > 8, their 2s.e. should prove a useful metric of the reproducibility of their mean. Three international geological reference materials and a Si isotope reference material, diatomite, were characterised via the critical mixture double-spiking technique. Our results for BHVO-2 (−0.276±0.011‰, 2s.e., n = 94, δ30/28Si), BIR-1 (−0.321±0.025‰, 2s.e., n = 27), JP-1 (−0.273±0.030‰, 2s.e., n = 19) and diatomite (1.244±0.025‰, 2s.e., n = 20) are consistent with literature data but much more precise.
spectroscopy,chemistry, analytical