Abstract:Dimethyl ether (DME) is a highly reactive diesel substitute that can be used as a pilot fuel to ignite low- reactivity methane (CH4) in heavy-duty engines. To optimize the efficiency and emissions of CH4/DME dual-fuel engines, it is crucial to study the fundamental combustion characteristics of DME mixed with methane. This study focuses on the influence of CH4 addition on the low-temperature oxidation (LTO) preparation stage and the thermal ignition (TI) preparation stage of DME in the two-stage ignition process, as these two stages respectively control the ignition delay of the first and second stages. The comparison is made between pure DME and a 50% CH4 and 50% DME blended fuel, operating under thermodynamic conditions representing the engine in- cylinder environment at 30 atm pressure, 650K temperature, and a stoichiometric equivalence ratio. The results show that the addition of methane hardly affects the control mechanism of the two-stage ignition of DME. Specifically, the LTO preparation stage is still promoted by the increase in OH radicals in the DME’s low-temperature oxygenation pathways to form KET, and the second stage is still controlled by the H2O2 loop mechanism. The kinetic analysis also reveals that methane addition can compete for some of the OH radicals in the LTO preparation stage, which has a suppressing effect on ignition. However, in the TI preparation stage, methane can promote the loop reaction of OH→HO2→H2O2→OH and promote ignition. For the operating conditions studied here, although methane consumes a total of 7.24% prior to thermal ignition, it only consumes 0.63% of the total amount in the LTO preparation stage and 1.81% of the total amount in the TI preparation stage. This indicates that methane is mainly consumed in the LTO stage, accounting for 65% of the total methane consumption amount. It can be concluded that the kinetic effect of methane has a relatively small impact on the ignition delay of the DME, at least for the conditions investigated here. In other words, the dilution and thermal effects caused by adding methane are the main reasons for the prolonged time of LTO/TI preparation. Overall, more fundamental research is warranted to understand the role of methane in the two-stage ignition process of DME, which could facilitate the development of CH4/DME dual-fuel engines.

Development and Verification of Simplified Methane/dimethyl Ether Mechanism for Micro-Combustion

Development And Verification Of The New Simplified Mechanism For Ch4/O-2/Co2 Laminar Premixed Flame Under High Pressure

Development and Validation of a New Reduced Diesel/natural Gas Mechanism under Engine-Relevant Conditions

The Effect of Methane Addition on the Low-Temperature Oxidation Preparation and the Thermal Ignition Preparation of Dimethyl Ether under Representative Engine In-Cylinder Thermal Conditions

Development of a Reduced Methane–Hydrogen–Polyoxymethylene Dimethyl Ether Mechanism under Engine-Relevant Conditions

Evaluation, Development, and Validation of a New Reduced Mechanism for Methane Oxy-Fuel Combustion

A Reduced DME-PRF Blended Fuel Chemical Kinetic Mechanism

Optimization of Kinetic Mechanism for Methane Combustion Based on Machine Learning

Development and Verification of a Reduced Dimethoxymethane/n-Heptane/toluene Kinetic Mechanism and Modelling for CI Engines

51-Step reduced mechanism for methane/air containing particles premixed combustion

Development and Validation of a Reduced Mechanism for Methane Using a New Integral Algorithm in a Premixed Flame

Simplified Chemical Kinetic Mechanism of Premixed Laminar Combustion of Methanol-Air Mixture

A reduced mechanism for the combustion of gasoline-ethanol blend on advanced engine combustion modes

A Methane Mechanism for Oxy-Fuel Combustion: Extinction Experiments, Model Validation, and Kinetic Analysis

A New Simplified Mechanism for Combustion of RP-3/Jet-A Kerosene

On kinetic mechanism for premixed laminar steady state methane-air flames

Development and validation of a reduced chemical kinetic model for dimethyl ether combustion

Laminar flame speed measurement and combustion mechanism optimization of methanol–air mixtures

Experimental and computational study of nonpremixed ignition of dimethyl ether in counterflow

Kinetic Modeling Study of Homogeneous Ignition of Dimethyl Ether/hydrogen and Dimethyl Ether/methane

Experimental and Numerical Study of Laminar Premixed Dimethyl Ether/methane–air Flame