Abstract:Methanol is an attractive oxygenate increasingly used as primary fuel for dual-fuel combustion technology yielding beneficial thermal-efficiency and emissions in modern engines. As such, it is significant to fundamentally understand the autoignition behavior of methanol/diesel mixtures. This study measured the ignition delay times (IDTs) of methanol/diesel blends with different mixing ratios (30%, 50%, 70% methanol by mol.) on a heated shock tube and a heated rapid compression machine at temperatures of 650-1450 K, pressures of 6-20 bar, and equivalence ratios of 0.5, 1.0 and 2.0. The typical two-stage ignition characteristics with the negative temperature coefficient response were observed for dual-fuel mixtures. In general, both the total and first-stage IDTs decrease with the increment of pressure and equivalence ratio as well as diesel proportion in mixtures. The simulation results performed with a published detailed mechanism in conjunction with a tri-component diesel surrogate demonstrate generally good agreement with the experimental data at all test conditions. Moreover, a crossover of IDTs occurs at a higher temperature (similar to 1500 K) for varying equivalence ratios, and experiment and simulation both exhibit a non-linear mixing effect of methanol addition on diesel ignition. Interestingly, simulation results clearly suggest a crossover (similar to 940 K) for mixtures with varying methanol content at an intermediate-temperature, where the IDT of the mixture with a lower methanol ratio becomes longer as the temperature is higher than that of the crossover. Furthermore, brute-force sensitivity analyses assisted with reaction path analysis were conducted to gain deeper insights into the autoignition chemistry of dual-fuel mixtures, especially for the chemical interaction between both fuels during the low-temperature oxidation process. It is found that methanol hardly generates center dot OH, whereas center dot OH is mainly produced by the low-temperature reaction pathways of diesel. Thus, center dot OH is the bridge for both fuels during the ignition process. At the high methanol ratio, the H-abstraction of diesel is mainly via center dot HO2 while CH3OH consumes a large percentage of center dot OH. Consequently, the competition between methanol and diesel for center dot OH radicals inhibits the overall reactivity of reaction network. In addition, the original data reported here lay a foundation for the development and validation of more accurate and robust dual-fuel kinetic schemes. (C) 2021 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

The Effect of Methane Addition on the Low-Temperature Oxidation Preparation and the Thermal Ignition Preparation of Dimethyl Ether under Representative Engine In-Cylinder Thermal Conditions

Investigation of the Effect of Ammonia Addition on the Two-Stage Ignition Process of Dimethyl Ether Based on Chemical Kinetic Analysis

Stage-wise Kinetic Analysis of Ammonia Addition Effects on Two-Stage Ignition in Dimethyl Ether

Study on Combustion Characteristics of a DI Diesel Engine Operating on Diesel/Methanol Blends

High Temperature Ignition and Combustion Enhancement by Dimethyl Ether Addition to Methane–air Mixtures

Study on Chemical Kinetics Mechanism of Ignition Characteristics of Dimethyl Ether Blended with Small Molecular Alkanes

Mechanism of Methane Addition Affects the Ignition Process of N-Heptane under Dual Fuel Engine-Like Conditions

Study on the Methanol Percentages Effect on Combustion and Emission of DME/Diesel Blended Fuel

Optical Study on the Effects of Methane Equivalence Ratio and Diesel Injection Mass on Diesel-Ignited Methane Combustion Process

Experimental Study on Thermo-Atmosphere Combustion of Direct-Injection Methanol Engine

Experimental and Numerical Study of Methanol/Dimethyl Ether Dual-Fuel Compound Combustion

Effect of ammonia reaction kinetics on the two-stage ignition mechanism of dimethyl ether

Autoignition of DME/C2H6 Mixtures under High-Pressure and Low-Temperature Conditions

Performance And Emissions Of Direct Injection Diesel Engine Fueled With Diesel Fuel Containing Dissolved Methane

Effects of Equivalence Ratio and Pilot Fuel Mass on Ignition/extinction and Pressure Oscillation in a Methane/diesel Engine with Pre-Chamber

Ignition Delay Time Measurements and Kinetic Modeling of Methane/diesel Mixtures at Elevated Pressures

Comparison of Ignition Reaction Mechanism of Diesel/Methane and Diesel/Methanol Dual Fuel

Autoignition Behavior of Methanol/diesel Mixtures: Experiments and Kinetic Modeling

Effects of Methanol Addition on the Combustion Process of the Methanol/Diesel Dual-Fuel Based on an Optical Engine

Shock tube measurements and kinetic investigation on the ignition delay times of methane/dimethyl ether mixtures

Impact of Small-Amount Diesel Addition on Methane Ignition Behind Reflected Shock Waves: Experiments and Modeling