Abstract:As a special type of through-flow device, bulb turbine pumps have been widely used in the Eastern Route of the South-to-North Water Diversion Project due to their compact structure, flexible installation process, easy maintenance, high efficiency, and strong adaptability. Therefore, structural improvements to enhance their safety and stability through fluid–structure interaction analysis have significant engineering value. This paper conducts static and transient fluid–structure interaction analyses of the bulb turbine pump structure. The results show that the rotor structure experiences the greatest deformation under low-flow conditions, with maximum deformation (2.13 mm) occurring at the leading edge of the impeller inlet and decreasing radially along a gradient distribution. The damping effect of water changes the mode shapes of the rotor structure, and although the vibration modes under wet conditions are similar to those in the air, the frequencies decrease to varying degrees. In transient analyses under different conditions, the total deformation of the rotor system is greater than in static analyses, showing significant regularity. Under low-flow conditions, the deformation of the pressure surface at the inlet and outlet of the blade tip is greater than that of the suction surface, with a maximum total deformation of 3.656 mm. The maximum total deformation under design flow is 3.337 mm; under high flow, it is 2.646 mm. The total deformation of the casing mainly occurs on both sides of the internal bulb body bottom support, with a maximum deformation of 2.0355 mm and an equivalent stress maximum of 44.848 MPa. The equivalent stress and total deformation distribution of the support structure are similar, located at the top support and trailing edge, with a maximum value of 22.94 MPa at the trailing edge. The research results provide technical references and theoretical foundations for the structural optimization of bulb turbine pumps.

Study on Stresses of Head Cover Bolts in a Pump Turbine Based on FSI

Stresses and Relative Stiffness of the Head Cover Bolts in a Pump Turbine

Computation of Static Stresses of the Head Cover Bolts in a Pump Turbine

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

Stress Analysis of Screw Connection of Key Structural Components in Pump Turbine

FEM Based Simulation Study on Static and Dynamic Properties of Port Plate in Axial Piston Pump

Stress Characteristic Analysis of Pump-Turbine Head Cover Bolts During Load Rejection Based on Measurement and Simulation

Research on the Flow-Induced Stress Characteristics of Head-Cover Bolts of a Pump-Turbine During Turbine Start-Up

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Optimization Analysis of Head Cover Structure of High Head Pump Turbine

Numerical simulation on the dynamic behavior of the bolt connecting the head-cover and stay ring in pumped storage unit

Failure Analysis on the Bolt Connecting the Head-Cover and Stay Ring in Pumped Storage Unit: Part Ⅰ-Experimental Study

Flow-Induced Dynamic Behavior of Head-Cover Bolts in a Prototype Pump-Turbine During Load Rejection

Failure analysis on the bolt connecting the head-cover and stay ring in pumped storage unit: Part I-Experimental study

Study on dynamic stress variation of head cover bolt during transient operation of pump turbine

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

An Investigation into the Swash Plate Vibration and Pressure Pulsation of Piston Pumps Based on Full Fluid-Structure Interactions

Fluid–Structure Coupling Analysis of the Stationary Structures of a Prototype Pump Turbine during Load Rejection

Analysis of Dynamic Stresses of Pump-Turbine Runner During Load Rejection Process in Turbine Mode

Experimental and Numerical Studies on Erosion Damage in Damping Holes on the Valve Plate of an Axial Piston Pump

Study on the Structural Characteristics of Bulb Tubular Pumps Based on Fluid–Structure Interaction