Abstract:The internal flow evolution of the pump was induced with impeller movement. In various conditions, the peak load on centrifugal blade under the change of rotational speed or flow rate was also changed. It would cause an error when inertia load with a safety coefficient (that was difficult to ascertain) was applied in structure design. In order to accurately analyze the impeller stress under various conditions and improve the reliability of pump, based on a mixed flow pump model, the stress distribution characteristic was analyzed under different flow rates and rotational speeds. Based on a three-dimensional calculation model including impeller, guide blade, inlet and outlet, the three-dimension incompressible turbulence flow in the centrifugal pump was simulated by using the standard k-epsilon turbulence model. Based on the sequentially coupled simulation approach, a three-dimensional finite element model of impeller was established, and the fluid-structure interaction method of the blade load transfer was discussed. The blades pressure from flow simulation, together with inertia force acting on the blade, was used as the blade loading on solid surface. The Finite Element Method (FEM) was used to calculate the stress distribution of the blade respectively under inertia load, or fluid load, or combined load. The results showed that the blade stress changed with flow rate and rotational speed. In all cases, the maximum stress on the blade appeared on the pressure side near the hub, and the maximum static stress increased with the decreasing of the flow rate and the increasing of rotational speed. There was a big difference on the static stress when inertia load, fluid load and combined loads was applied respectively. In order to more accurately calculate the stress distribution, the structure analysis should be conducted due to combined loads. The results could provide basis for the stress analysis and structure optimization of pump.

Stresses and Relative Stiffness of the Head Cover Bolts in a Pump Turbine

Computation of Static Stresses of the Head Cover Bolts in a Pump Turbine

Study on Stresses of Head Cover Bolts in a Pump Turbine Based on FSI

FEM-based Multi-field Coupling Stress Analyses of the Cylinder-bolts System in a Gas Turbine Power Plant

Stress Analysis of Screw Connection of Key Structural Components in Pump Turbine

Pressure pulsation analysis of runner and draft tube of pump turbine under different working conditions

Stress Characteristic Analysis of Pump-Turbine Head Cover Bolts During Load Rejection Based on Measurement and Simulation

Research on the Flow-Induced Stress Characteristics of Head-Cover Bolts of a Pump-Turbine During Turbine Start-Up

FEM Based Simulation Study on Static and Dynamic Properties of Port Plate in Axial Piston Pump

Optimization Analysis of Head Cover Structure of High Head Pump Turbine

Computation of Dynamic Stresses in Piston Rods Caused by Unsteady Hydraulic Loads

Computation of Static and Dynamic Stresses of A Bulb Tubular Turbine

Flow-Induced Dynamic Behavior of Head-Cover Bolts in a Prototype Pump-Turbine During Load Rejection

Numerical simulation on the dynamic behavior of the bolt connecting the head-cover and stay ring in pumped storage unit

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Study on dynamic stress variation of head cover bolt during transient operation of pump turbine

Failure Analysis on the Bolt Connecting the Head-Cover and Stay Ring in Pumped Storage Unit: Part Ⅰ-Experimental Study

The Influence of Bolt Joint Characteristics on Bending Stiffness of Rotor Joint Surface

Failure analysis on the bolt connecting the head-cover and stay ring in pumped storage unit: Part I-Experimental study

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Unbalanced Force Analysis on Valve Core Clamping in Hydraulic Spool Valves